Kolcraft Contours Options Hoja De Instrucciones página 6

▲
1 & 2
3 & 4
5
7
To Assemble Rear Wheels
★
6
There is a LEFT and RIGHT brake
1
assembly. Be sure to assemble them
onto the correct rear leg tube. LEFT
from RIGHT will be identified as shown.
Each brake assembly will have either a
triangle or a star on the bottom of the
part.
• TRIANGLE = "▲" LEFT
• STAR = "★" RIGHT
Position brake assembly as shown, with
2
the brake lever pointing towards the
stroller handle. Push brake assembly
completely onto rear leg tube.
Remove and discard protective foam
3
sleeves from ends of axle. Insert axle
into outside hole of brake assembly and
slide it through frame.
Slide a rear wheel onto the axle then
4
slide a washer onto the axle.
Fit straight part of cotter pin through
5
hole on axle as shown.
Assemble other rear wheel to axle with
6
washer and cotter pin.
Line up each of the 4 tabs of the hub
7
cap with the 4 slots in the wheel and
snap hub cap into place. Repeat for
second side.