Metabo HPT N 1804DA Instrucciones Y Manual De Seguridad página 19

● Make sure the trigger is locked when not
fi ring staples.
This Stapler has a lock mechanism to prevent the
staples from being fi red.
Set the lock lever at the
trigger.
Slide the lock lever to the
Stapler is to be used, and to the
it is not in use.
Trigger
Lock lever
● Never use Stapler unless push lever is operating
properly.
Before actually beginning the stapling work, test the
Stapler by using the checklist below. Conduct the tests in
the following order.
If abnormal operation occurs, stop using the Stapler
and contact a metabo HPT authorized service center
immediately.
(1) REMOVE ALL STAPLES AND BATTERY FROM
STAPLER.
□ ALL SCREWS MUST BE TIGHTENED.
□ THE PUSH LEVER AND TRIGGER MUST MOVE
SMOOTHLY.
Trigger
Push lever
WARNING
position to lock the
position when the
position when
Lock position
Free position
(2) Installing the battery.
Do not operate the push lever or trigger while
installing the battery.
Latch
Push
(3) Turn on the Power switch.
Stapling operation
indicator
Stapling operation
switch
Turn on the Power switch by push and hold on Power
switch more than 1 second.
Make sure the power indicator is lighting in green,
and stapling operation indicator is lighting in blue.
(FULL SEQUENTIAL ACTUATION MECHANISM)
NOTE
● Do not press the push lever and/or pull the trigger
during the process of turning the power switch ON.
Doing so will prevent the power switch from turning
ON.
Light in blue
English
Handle
Battery
Insert Pull out
Power indicator
Battery indicator
Power
switch
Light in green
19