Hart HTMS01 Manual Del Operador página 11

FEATURES
KNOW YOUR COMPOUND MITER SAW
See Figures 1 - 2.
The safe use of this product requires an understanding of
the information on the tool and in this operator's manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
7-1/4 IN. BLADE
A 7-1/4 in. blade is included with the compound miter saw.
It will cut materials up to 1-1/2 in. thick or 4-1/4 in. wide,
depending upon the angle at which the cut is being made.
BEVEL LOCK KNOB
See Figure 3.
The bevel lock knob securely locks your compound miter
saw at desired bevel angles. A positive stop adjustment
screw has been provided on each side of the saw arm.
These adjustment screws are for making fine adjustments
at 0° and 45°.
BLADE WRENCH STORAGE
A blade wrench is packed with the saw. One end of the
wrench is a Phillips screwdriver and the other end is a hex
key. Use the hex key end when installing or removing blade
and the Phillips end when removing or loosening screws.
A storage area for the blade wrench is located on the back
of the miter fence.
HANDLE AREA
See Figure 3.
For convenience when carrying or transporting the miter saw
from one place to another, handle areas have been provided
on either side of the saw base. To transport, turn off and
unplug the saw, securely tighten the slide lock knob, then
lower the saw arm and lock it in the down position. Lock
saw arm by pushing the lock pin in.
NOTE: DO NOT perform any cutting operation with the saw
in the locked position.
MITER FENCE
The miter fence on the compound miter saw has been
provided to hold your workpiece securely against when
making all cuts.
MITER LOCK KNOB
See Figure 4.
The miter lock knob securely locks the saw at desired miter
angles. Turn the miter lock knob clockwise to lock the saw
in place. To release the saw, turn the the miter lock knob
counterclockwise and depress the detent release button.
FIG. 3
"D"
HANDLE
HANDLE
AREA
BLADE
WRENCH
SAW ARM LOCKED IN DOWN POSITION
FIG. 4
DETENT
RELEASE
BUTTON
TIGHTEN
11 – English
LOCK PIN
LOCK KNOB
TO
MITER
LOCK KNOB
PARTIAL
SLIDING
FENCE
BEVEL
TO
LOOSEN