Lega 5409T Manual Del Usuario página 14

Barra motorizada "top"
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

ATTENTION
The cage must rotate slowly at the start to avoid damaging the frames that are still full of honey, even if, in the
TOP extractor, the acceleration is controlled by the electronic board inside the control panel.
After a few minutes of extraction the cage can be taken to the maximum rpm, having partially emptied the frames.
This device also facilitates stability of the extractor.
Evaluate, however, which is the most appropriate maximum speed based on the load of frames and the diameter
of the extractor. The larger the extractor, the lower the maximum rotation speed must be.
The rotation speed can be changed at any time by pressing the potentiometer.
To stop the extractor, place the switch in the central position 0 - STOP.
Wait for complete stopping of the cage which, due to the effect of inertia force, will continue to rotate for a few seconds.
At this point the lid can be opened to perform the discharge/loading operations.
ATTENTION
In the event of a current overload or a power failure, the extractor will stop working and remain stationary for 55
seconds.
A voltage overload may be due to the fact that the cage does not rotate freely but is blocked either by a broken
frame or by an excessive amount of honey inside the vat.
PREPARATION AND CHECKS PRECEDING THE FIRST START-UP
Check that the mechanical and electrical parts, are intact.
Check that the internal components of the extractor are well clean before inserting the boxes.
Possible problems and their solution
Problem found
The cage does not rotate
The extractor is noisy
Costruzioni Apistiche – via Maestri del Lavoro 23 – 48018 Faenza
www.legaitaly.com - Tel 054626834 – Fax 054628279 – P.iva 00043230390
Cause
Insufficient voltage to the motor
Central pin locking
Sheared
off
central
engagement rod
Frames loaded in an unbalanced
way
Ball in the central bush not present Insert a new ball
Solution
Check the electrical system
Lubricate the bush with Vaseline
grease
pin
Replace it
Arrange the frames in a better
layout
14 / 38

Publicidad

Tabla de contenido
loading

Productos relacionados para Lega 5409T

Este manual también es adecuado para:

5410t5409ta5410ta

Tabla de contenido