Flight Test; Gyroscope And Attitude Calibration - QIMMIQ QIF Gemini Manual De Usuario

Roll ( lean ) left /right
Drone Rolls left
Drone Flips forward

7) Flight test

- Put the aircraft on a leveled placed at 5 meters from any person / obstacle, place mix switch to 1, power on the drone and
the remote controller, wait until the drone stops beeping.
- Press the middle button to arm the motors / carefully take off / carefully test any controls.
- Land the aircraft / disarm using the middle button / then remove the battery / put the remote controller off / test is over
- You could use any 5.8Ghz video receiving equipement to get FPV video.
Recommendation
- Always use flight mode 1 « Stabilized » for take off and first flights. Don't hesitate to switch to this mode when you encounter
some difficulties.
Loss of signal
- As the remote controller signal is loss, the motors speed lowers so the drone loose its altitude slowly, allowing to regain
control over it in most cases, or allowing him to land on its own. The buzzer might help you to locate it in the forest / grass.

8) Gyroscope and attitude calibration

When the aircraft deviates with a large range, you need to calibrate the gyroscope and attitude.
1) Put the aircraft on a horizontal place and power it on
2) Turn on the remote controller, push the left stick to top right corner and right stick to top left corner at the same time, the
23
Use right stick right or left to control the roll rate ( lean ) of the aircraft
Drone rolls right
Drone Flips backward
Stunts : flip & roll's
Are only available in mode 2 or 3
Attention :
- Always select wide open spaces for flying
- Rolls and flips are best suited for experienced pilots.
- Match throttle power to carefully manage altitude.