Hardware - E-Z-GO REFRESHER 1200 Manual Del Propietario Y Guia De Servicio

Read all of manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
•
Remove spark plugs (Refer to SPARK PLUGS on
page 24) and pour about 1 oz. (30 ml) of engine oil
into each cylinder. Replace spark plugs, ground
spark plug wires and use starter to turn engine
over a few seconds to distribute oil.
•
Add a gasoline additive to the tank in accordance
with the manufacturer's recommendations.
•
Reattach fuel line to tank and drive the vehicle for
several minutes to circulate the additive through
the carburetor.
•
While engine is still warm, change oil (Refer to
CHANGING THE OIL on page 18).
•
Clean body, chassis and engine of debris, mud,
chaff or grass (Refer to AIR INTAKE AND COOL-
ING FINS on page 23).
installed are considered 'wet' and require approximately 80% of the torque required for 'dry' fasteners.
BOLT SIZE 1/4"
4
Grade 2
(5)
6
Grade 5
(8)
6
Grade 8
(8)
BOLT SIZE M4
Class 5.8 1
(Grade 2) (2)
5.8
2
Class 8.8
8.8 (3)
(Grade 5)
3
Class 10.9
10.9 (4)
(Grade 8)
Ref Tsp 1
OPERATION AND SERVICE INFORMATION
ALL TORQUE FIGURES ARE IN FT. LBS. (Nm)
Unless otherwise noted in text, tighten all hardware in accordance with this chart.
This chart specifies 'lubricated' torque figures. Fasteners that are plated or lubricated when
5/16" 3/8" 7/16"
8 15 24
(11) (20) (33)
13 23 35
(18) (31) (47)
18 35 55
(24) (47) (75)
M5 M6 M8
2 4 10
(3) (6) (14)
4 7 18
(6) (10) (24)
6 10 25
(8) (14) (34)
Fig. 38 Torque Specifications
Owner's Manual and Service Guide

HARDWARE

Periodically, the vehicle should be inspected for loose
fasteners. Fasteners should be tightened in accordance
with the Torque Specifications table (Ref. Fig. 38 on page
25).
Use care when tightening fasteners and refer to the
Technician's Repair and Service Manual for specific
torque values.
Generally, three grades of hardware are used in the vehi-
cle. Grade 5 hardware can be identified by the three
marks on the hexagonal head and grade 8 hardware is
identified by 6 marks on the head. Unmarked hardware is
Grade 2 (Ref. Fig. 38 on page 25).
1/2" 9/16" 5/8"
35 55 75
(47) (75) (102)
55 80 110
(75) (108) (149)
80 110 170
(108) (149) (230)
M10 M12 M14
20 35 55
(27) (47) (76.4)
35 61 97
(47) (83) (131)
49 86 136
(66) (117) (184)
3/4" 7/8" 1"
130 125 190
(176) (169) (258)
200 320 480
(271) (434) (651)
280 460 680
(380) (624) (922)
Page 25