Elite TIG AC/DC 225 Manual De Usuario página 47

• Make sure the power board has the 60 Amp thermomagnetic switch and the ground connection
properly connected.
• Make sure the power cord is properly connected to the electrical outlet. If you do install a plug, be
sure to respect the cable color codes. This should not be modi ed in any way, use plugs in accordance
with the standard to reduce the risk of electric shock.
• Turn o the equipment when you nish your work and disconnect it from the electrical outlet.
• Do not leave the equipment connected to the electrical outlet or with the switch in the ON position
without attention.
• Only place the electrode holder clamp or torch on an insulated surface regardless of whether the
electrode connected or not. Avoid shorting with the work clamp (ground). Remove the electrode from
the electrode holder if the welding process is interrupted or has ended.
• Place the machine switch in the OFF position at the rear of the equipment and disconnect the power
cord from the electrical outlet each time changes are made in the work area, when removing the
electrode holder, torch, or clamp. work (ground) and when transporting or cleaning equipment.
• Pay special attention to the condition of the power cable, if the cable is damaged, repair it with a
quali ed electrician, PREFERENTLY take it to an Authorized Service Center by UJUETA MÉXCIO, S.A. DE
C.V.
• Avoid tensioning the cables, do not move the machine by dragging it from the cables, if you need to
move it, disconnect it from the outlet. Do not use the power cord to suspend the machine, move it, or
pull it to disconnect it from the electrical outlet. Keep the power cord away from heat, oils, pointed
surfaces, or moving parts. A cable in poor condition increases the risk of electric shock.
• Pay attention to the condition of the electrode holder, torch and work clamp (ground) cables,
especially if they malfunction during the welding application or when the application result is not
adequate. Check the whole set: connectors, electrode holder, torch, work clamp, repair or replace
them with a quali ed electrician, PREFERENTLY take it to an Authorized Service Center by UJUETA
MÉXICO, S.A. DE C.V.
• Avoid contact with the electrical circuit, it can have negative consequences for the operator's health
2
www.ELITETOOLS.co
Keep Working