Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
6 Maintenance and cleaning
6.1 Loading Door Inner Surface
The hair and fibres that are separated from the
laundry during drying process is collected by
the Fibre Filter.
C
NOTE
•
Fibres are formed during wearing and
washing clothes.
•
You can clean the filter slot with a
vacuum cleaner.
A
WARNING!
•
After each drying cycle, clean the fibre
filter and the inner surface of the loading
door.
To clean the fibre filter:
• Open the loading door.
• Hold the first part (inner filter) of the two
part fibre filter and remove it by pulling it
upwards.
• Collect the hair, fibres and cotton balls with
hand or with a soft cloth.
• Remove the second part (outer filter) by
pulling it upwards.
C
NOTE
•
Ensure that hair, fibre and cotton balls do
not fall into the slot where the filters are
installed.
• Open both fibre filters (inner and outer
filters) remove the hair, fibre, cotton balls
with your damp hand or a vacuum cleaner
or a cloth.
Dryer / User Manual
• Clean both filters under water running in
reverse direction of fibre accumulation
or with a soft brush. Dry the filter before
placing it back.
• Clean the loading door interior and its
washer with a soft damp cloth.
6.2 Cleaning the sensors
•
There are temperature sensor in the
dryer that detect whether the laundry is
dry or not.
To clean the sensors:
•
Open the loading door of the dryer.
•
Remove the lint filter by pulling it up.
•
Clean the sensor with your hand if any
fluff accumulation on it.
• Insert the fibre filters
on one another and
place it back in its
place.
65
Publicidad
Tabla de contenido
