Maintenance And Cleaning - Beko DV 1160 Manual Del Usuario

5

Maintenance and cleaning

Cover filter
Lint and fibres released from the laundry to the
air during the drying cycle are collected in the
"Cover Filter".
C
Such fibre and lint are generally formed
during wearing and washing.
C
Always clean the filter after each drying
process.
C
You can clean the filter and filter area by
vacuum cleaner.
To clean the filter:
1. Open the loading door.
2. Remove the cover filter by pulling it up and
open the filter.
3. Clean lint, fibre, and cotton raveling by hand
or with a soft piece of cloth.
4. Close the filter and place it back into its seat.
C
Clogging may arise on the filter surface after
using your machine for some time; if this
occurs, wash the filter with water and dry it
before using again.
Sensor (models with a sensor)
There are humidity sensors in your dryer that
detect whether the laundry is dry or not.
To clean the sensor:
1. Open the loading door of the dryer.
2. Allow the machine to cool down if drying has
been carried out.
3. Wipe the metal sensors with a soft cloth,
dampened with vinegar and dry them.
C
Clean metal sensors 4 times a year.
A
Never use solvents, cleaning agents or
similar substances when cleaning since these
materials can cause fire and explosion!
Water tank (Products equipped with a
condenser);
The moisture in the damp laundry is taken from
the laundry and condensed. Drain the water
tank after each drying cycle or during drying
when "Water tank" warning light turns on.
C
You can use the water in the water tank in
your steam irons or air humidifiers.
A
Condensed water is not drinkable!
A
Never take out the water tank when the
programme is running!
Water tank may be located in two different
places as indicated below, depending on the
model of your dryer.
- Inside the drawer on the panel
- Behind the kick plate cover
If you forget to drain the water tank, your dryer
will stop during the following drying cycles
when the water tank is full and the "Water tank"
warning light will turn on. If this is the case, press
the "Start/Pause/Cancel" button to resume the
drying cycle after draining the water tank.
To drain the water tank:
1. Carefully remove the water tank by opening
the kick plate cover/pulling the drawer.
2. Drain the water by opening the water tank
cover.
3. If there is lint accumulation in the water tank
cover, clean it and press to close.
4. Place the water tank into its seat.
For the condenser (products with a
condenser)
Hot and humid air in the condenser is cooled
with the cold air from the room. Thus, the humid
air circulating in your dryer is condensed and
then pumped into the tank.
C
Clean the condenser after every 15 drying
cycles or once a month.
To clean the condenser:
1. If a drying process has been carried out, open
the door of the product and wait until it cools
down.
2. Unlock the 4 condenser locks after opening
the kick plate.
3. Pull out the condenser.
4. Clean the condenser with pressurized water
15 - EN