How To Assemble Your Ceiling Fan - Fanimation FP7644 Serie Manual Del Usuario

How to Assemble Your Ceiling Fan

1. Prior to assembly, set aside and save the hardware
bags included in the packaging. Remove the hanger
ball by loosening the set screw in the hanger ball until
the ball falls freely down the downrod. Remove the pin
from the downrod, then remove the hanger ball.
Retain the pin and hanger ball for reinstallation in
Step 6. (Figure1)
2. Remove the hairpin clip and clevis pin from the
bottom of downrod. Retain the pin and clip for
reinstallation in Step 4. (Figure 2)
3. Loosen the two set screws and locking nuts in the
downrod support of the motor assembly. Route the
black, white, blue wires and safety cable through the
downrod. (Figure 3)
4. Slide downrod into the downrod support on top of
the motor. Install the clevis pin by aligning the holes in
the downrod support with holes in the downrod.
Secure clevis pin with hairpin clip. Install the two set
screws with nuts in the downrod support. Securely
tighten the set screws with screwdriver then fully
tighten the nuts using the hex wrench. (Figure 4)
WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the set screws and nuts are
securely tightened. Failure to do so could result in the
fan falling.
Hanger
Ball
Hairpin Clip
Black, White, Blue
wires and Safety Cable
Set Screws
and Nuts (2)
Downrod
Set Screws
and Nuts (2)
7
Pin
Set screw
Figure 1
Clevis Pin
Figure 2
Downrod Support
Figure 3
Clevis Pin
Hairpin Clip
Figure 4