Installation To Single Wood Stud Wall - PEERLESS PeerCare SF632-AB Instalación Y Montaje

Installation to Single Wood Stud Wall

• Installer must verify that the supporting surface will safely support the combined load of the equipment and all
attached hardware and components.
• Tighten wood screws so that wall plate is fi rmly attached, but do not overtighten. Overtightening can damage the
screws, greatly reducing their holding power.
• Never tighten in excess of 80 in. • lb (9 N.M.).
• Make sure that mounting screws are anchored into the center of the stud. The use of an "edge to edge" stud fi nder
is highly recommended.
• Hardware provided is for attachment of mount through standard thickness drywall or plaster into wood studs.
Installers are responsible to provide hardware for other types of mounting situations (not evaluated by UL).
Use a stud fi nder to locate the edges of the stud. Use of an edge-to-edge stud fi nder is highly recommended.
1
Based on its edges, draw a vertical line down the stud's center. Place wall plate (A) on wall as a template, making
sure that the two mounting holes are over the stud centerline. Level plate, and mark the center of the two holes.
Drill two 5/32" (4 mm) dia. holes 2.5" (64 mm) deep. Make sure that the wall plate is level, secure it using
two #14 x 2.5" wood screws (G) as shown.
Skip to step 2 on page 6 for VESA 200 mm and 200 mm x 100 mm patterns.
Skip to step 2 on page 7 for VESA 75 mm and 100 mm patterns.
G
WARNING
A
4 of 29
ISSUED: 09-19-11 SHEET #: 203-9041-2 02-08-12