Model Heat Pro Deluxe How-To Use; Model Heat Pro Deluxe Specifications; Operation Of The Model Heat Pro Deluxe; How To Attach Accessories To The Model Heat Pro Deluxe - Black and Decker HEAT PRO Manual De Instrucciones

Model HEAT PRO DELUXE How-to Use

The Model HEAT PRO DELUXE kit includes one
hot air tool with LED display, specialized scrapers,
nozzles and carrying case.

Model HEAT PRO DELUXE Specifications

Wattage
Temperature
Volts
AMPS
Output
Weight
Cord Length
Settings

Operation of the Model HEAT PRO DELUXE

The following instructions are a general guideline
for using the Model HEAT PRO DELUXE hot air tool.
Every project is different so use these instructions
as a starting point to determine the best heat set-
ting and distance for your project. Before plugging
the Model HEAT PRO DELUXE into an electrical out-
let make sure the switch is in the Off position.
1. Plug into a standard outlet.
2. To start slide the switch to either the Lo or Hi
position. The motor-driven fan noise will indi-
cate the unit is running. The heating coil will
light up and slowly turn red.
Note: Smoke may appear during the initial start
up due to the burning of manufacturing oils.
The smoke should disappear in less than a
minute.
Caution: If the blower motor in the hot air tool
does not turn on when the switch is set to
either Lo or Hi, turn the switch to Off imme-
diately. The heating element will burn out if
it is not cooled by the blower.
3. For instructions on how to strip paint go to sec-
tion HEAT GUN OPERATIONAL GUIDELINES,
How to Strip Paint.
4. Use the dial to increase (+) or decrease (-) heat
as needed. The LED lights will indicate the
temperature level from low to high.
5. To turn off, slide the switch to the Off position
and unplug. Make sure the Model HEAT PRO
DELUXE is completely cooled before storing.
MODEL HEAT PRO DELUXE
44 to 1250 Watts
Low 100°F / High 1100°F
120 Volts
0.5 to 10.5 AMPS
68 BTU
1.8 lbs.
6 feet
Hi, Lo, Off
All Purpose
Deflector
Scraper
Nozzle
Window Protector
Nozzle
How To Attach Accessories to the Model HEAT
PRO DELUXE
1. Set the Model HEAT PRO DELUXE upright on a
level surface, make sure tip is cool.
2. Set the accessory nozzle on the top of the open
nozzle and push firmly into place.
3. To remove, set hot air tool with nozzle facing
up; wait for it to cool.
4. Pull the accessory nozzle off the top using a
twisting motion and straight pull.
5. Only use accessories designed for this hot air
tool.
Concentrator
Heart
Nozzle
Scraper
Triangle
Scraper
Hook
Nozzle
Scraper
Combination
Handle
Scraper
ENGLISH 10