Model Heat Pro Plus How-To Use; Model Heat Pro Plus Specifications; Operation Of The Model Heat Pro Plus; How To Attach Accessories To The Model Heat Pro Plus - Black and Decker HEAT PRO Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Model HEAT PRO PLUS How-to Use

The Model HEAT PRO PLUS kit includes one hot air
tool, one concentrator nozzle and one scraper nozzle.

Model HEAT PRO PLUS Specifications

Wattage
Temperature
Volts
AMPS
Output
Weight
Cord Length
Settings

Operation of the Model HEAT PRO PLUS

The following instructions are a general guideline
for using the Model HEAT PRO PLUS hot air tool.
Every project is different so use these instructions
as a starting point to determine the best heat set-
ting and distance for your project.
Before plugging the Model HEAT PRO PLUS into
an electrical outlet make sure the switch is in the
Off position.
1. Plug into a standard 3-hole outlet.
2. To start, slide the switch to either the Low or
High position. The motor-driven fan noise will
indicate the unit is running. The heating coil
will light up and slowly turn red.
Note: Smoke may appear during the initial start
up due to the burning of manufacturing oils.
The smoke should disappear in less than a
minute.
Caution: If the blower motor in the hot air tool
does not turn on when the switch is set to
either Low or High, turn the switch to Off
immediately. The heating element will burn
out if it is not cooled by the blower.
3. For instructions on how to strip paint go to
section HOT AIR TOOL OPERATIONAL GUIDE-
LINES, How to Strip Paint.
4. To turn off when finished, slide the switch to
the Cool position, point the nozzle up and let
run until cool. Then slide the switch to the Off
position and unplug. Set the Model HEAT PRO
PLUS upright on a stable, level surface. This
will speed up the cooling process because the
MODEL HEAT PRO PLUS
up to 1300 Watts
Dual Temperatures
Low 600°F / High 1100°F
120 Volts
11 AMPS
74 BTU
1.8 lbs.
6 feet
High, Low, Cool, Off
Concentrator
Scraper
Nozzle
air will flow naturally upward over the heating
element. Allow the Model HEAT PRO PLUS to
cool completely. Make sure the Model HEAT
PRO PLUS is completely cooled before storing.
How To Attach Accessories to the Model HEAT
PRO PLUS
1. Set the Model HEAT PRO PLUS upright on a
level surface, make sure tip is cool.
2. Set the accessory nozzle on the top of the open
nozzle and push firmly into place.
3. To remove, set hot air tool with nozzle facing
up; wait for it to cool.
4. Pull the accessory nozzle off the top using a
twisting motion and straight pull.
5. Only use accessories designed for this hot air
tool.
ENGLISH 8

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Heat pro plusHeat pro deluxe

Tabla de contenido