Bond 6103P Manual Del Propietário página 8

TO LIGHT
Before Beginning ●Read and understand the instructions thoroughly.
TIPS:
1.Locate the burner control knob and make sure it is in the "OFF" position.
2.Connect propane (LP) cylinder. (See above pages).
3.Push in igniter button to create sparks at the electrode and hold.
4.Push and turn burner control knob to the "HI" position. Continue to push the control
knob for 15-30 seconds after ignition.
5.If ignition does not occur within 30 seconds, turn the burner control knob to "OFF", wait
5 minutes for gas to clear and repeat the lighting procedure. If burner still will not light,
refer to the Troubleshooting Section.
6.Once the appliance is lit, flame height can be changed by adjusting the burner control
knob between the "HIGH" and "LOW" positions.
7.Always check burner flames periodically to ensure proper operation. Flames should be
mostly yellow with some blue for best performance. (See diagram below)
If the burner does not ignite with the burner control valve open, gas will
continue to flow out of the burner and could accidentally ignite causing injury or
USING A LONG MATCH OR LIGHTER
1. Connect propane (LP) cylinder (see above pages).
2. Before lighting, remove the glass and move the lava rocks with a small shovel to
allow access to the burner.
WARNING: Lava rocks can become very hot. DO NOT touch unless they are
completely cooled.
3. Locate the burner control knob and make sure it is in
the "OFF" position.
4. Wearing heat resistant gloves position a long lit
match or lit long neck lighter close to the burner ports.
DO NOT lean over the burner while lighting.
5. Push and turn burner control knob to the "HI" position.
The burner should light within 5 seconds.
6. If ignition does occur within 5 seconds, turn the
burner control knob to "OFF", wait 5 minutes for gas
to clear and repeat the lighting procedure. If burner
still will not light, refer to the Troubleshooting Section.
7. Flame height can be changed by adjusting the burner
control knob between the "LOW" and "HIGH"
positions.
8. Replace the glass.
9. Always check burner flames periodically to ensure proper operation. Flames should
be mostly yellow with some blue for best performance.
●Check and make sure that all parts are present.
●For future reference, save this instruction sheet.
CAUTION
property damage.
8