Troubleshooting / Specifications; Specifications - LG DLHX4072 Serie Manual Del Propietário

Before calling for service (cont.)
Problem
Garments are not • Number of garments or load
uniformly damp size not properly selected at the
after Easy Iron beginning of the cycle.
Water drips from • This is normal.
door during
Steam Cycle
Steam is not • This is normal.
visible during
Steam Cycle
Drum does not • This is normal.
turn during Steam
Cycle
Cannot see steam • This is normal.
vapor at the
beginning of
cycle
The display shows • More Time button pressed.
Odors remain in • Steam Fresh™ did not remove
clothing after odor completely.
Steam Fresh™
CHECK FILTER • Lint filter is almost clogged or
light is on during full.
the drying cycle
TM
FLOW SENSE • Ductwork is too long or has too
indicator shows many turns/restrictions.
four bars during
• Significant blockage of the
the drying cycle
ductwork due to lint buildup or
debris.
• The appliance has detected a
restriction in the external dryer
venting.

SPECIFICATIONS

Steam Dryer™ models
Description
Electrical Requirements*
Dimensions
Net Weight
Drying Capacity
- Steam Cycle
Allowable temperature
Possible Causes
DlHx4072*
Steam Dryer
Please refer to the rating label regarding detailed information.
27" (W) X 30" (D) X 39" (H), 51" (D with door open)
68.6 cm (W) X 76.1 cm (D) X 99.1 cm (H), 129.7 cm (D with door open)
167.5lbs(76kg)
IEC 7.3 cu.ft. (8 lb/3.6 kg)
41°F~ 95°F(5°C ~ 35°C)

troUBlEshootIng / sPECIFICatIons

Solutions
• Select the correct number or garments or load size before
starting the cycle.
• Condensation will normally form on the inside of the
dryer door during steam operation. Some condensation
may drip out the bottom of the door.
• Steam vapor is difficult to see when the door is closed.
However, condensation will normally form on the inside of
the dryer door if the steam system is operating normally.
• The drum is turned off so that the steam vapor remains in
the drum. The drum will normally turn for about 2 seconds
once a minute.
• Steam is released at different stages of the cycle for each
option.
• This display indicates that the steam option has been set
for a " " item such as a comforter.
Press the Less Time button to reduce the indicated load
size.
• Fabrics containing strong odors should be washed in a
normal cycle.
• Pause the drying cycle and clean the lint filter.
• Install a shorter or straighter duct run. See the Installation
Instructions.
• Ductwork should be checked/cleaned soon.
Dryer can be used in this condition, but drying times may
be longer.
• If exhaust restrictions are sensed by the FLOW SENSE
system, the indicator will remain on for two hours after
the end of the cycle. Opening the door or pressing the
POWER button will turn off the display.
51
TM