Hilti SID 14-­A Manual Del Usuario página 13

5.3 Fitting an accessory tool
SID 14­A
SID 22­A
1. Check that the connection end of the accessory tool is clean.
Result
The connection end is dirty.
▶ Clean the connection end.
2. Set the forward/reverse switch to the middle position or remove the battery from the power tool.
3. Push the accessory tool into the chuck as far as it will go (until it engages).
5.4 Removing the accessory tool
SID 14­A
SID 22­A
CAUTION
Risk of injury. The accessory tool may be hot or have sharp edges.
▶ Wear protective gloves when using the power tool and when changing accessory tools.
1. Set the forward/reverse switch to the middle position or remove the battery from the power tool.
2. Pull the chuck ring forward and hold it in this position.
3. Pull the accessory tool out of the chuck.
4. Release the chuck ring.
5.5 Fitting an accessory tool
SIW 14­A
SIW 22­A
1. Check that the connection end of the accessory tool is clean.
Result
The connection end is dirty.
▶ Clean the connection end.
2. Set the forward/reverse switch to the middle position or remove the battery from the power tool.
3. Bring the notch in the accessory tool into alignment with the ball on the square drive.
4. Push the accessory tool onto the square drive until it engages.
5.6 Removing the accessory tool
SIW 14­A
SIW 22­A
CAUTION
Risk of injury. The accessory tool may be hot or have sharp edges.
▶ Wear protective gloves when using the power tool and when changing accessory tools.
1. Set the forward/reverse switch to the middle position or remove the battery from the power tool.
2. Pull the accessory tool off the square drive.
5.7 Setting the torque
Technical data
Model SID ... (SID 14­A OR SID 22­A) ?? → page 5
Model SIW ... (SIW 14­A OR SIW 22­A) ?? → page 6
Printed: 27.07.2016 | Doc-Nr: PUB / 5293007 / 000 / 00
4
5
6
7
8
7