Product Setup - D-Link N300 Guía De Instalación Rápida

PROdUCT SETUP

SetUP
SELECT YOUR METHOd
You may set up the DAP-1325 using WI-FI Protected Setup (WPS) (recommended),
the QRS Mobile App, or a web browser.
SETTING UP THE dAP-1325 USING WI-FI PROTECTEd SETUP (WPS)
NOTE: Your source router or AP must feature a WPS button to use WPS.
SMART SIGNAL LEdS
OPtiMiZe exteNdeR LOCatiON
2
Step 1
Fully extend the antennas to provide optimal wireless
coverage. Plug the DAP-1325 into a wall outlet, and wait
until the Status/WPS LED is blinking amber.
Step 2
Push the WPS button on your source wireless router
or AP, then push the WPS button on the DAP-1325.
The Status/WPS LED will start flashing green. Allow
up to two minutes for the process to finish. The Status/
WPS LED will turn solid green when the DAP-1325 has
connected successfully.
Step 3
Connect your clients to an extension network created by
the DAP-1325:
(Your router's SSID)-EXT
After WPS, the password of (Your router's SSID)-EXT
will be the same as the source wireless network's.
If the Smart Signal LED has a single amber bar after
the connection process has finished, the DAP-1325 has
established a poor quality connection. To improve the
connection quality, the DAP-1325 should be relocated
to a wall outlet closer to the source wireless router or
AP. The more lit bars on the Signal LED, the better the
wireless signal.
daP-1325