Manuales relacionados para Excalibur AL-560
Resumen de contenidos para Excalibur AL-560
- Página 1 AL-560 REMOTE KEYLESS ENTRY & SECURITY SYSTEM Installation Guide January 27th, 2016 Temporary cover. Color cover is in a separate file.
-
Página 2: Tabla De Contenido
Table Of Contents Owner’s Guide Installation Instructions Arming the System ....... 3 How To Program Remote Control ..... 9 Disarming the System ....4 How To Program Features ...... 10 Emergency Override ....4 Programmable Features ....10 - 12 System Armed &... - Página 3 Emergency Override: THEN WITHIN 10 SECONDS PRESS & RELEASE VALET BUTTON Panic: Press & Hold the “Lock” Button for 3 Sec’s, with the ignition “Off” THE SIREN WILL SOUND THE PARKING LIGHTS Hold 3 seconds WILL FLASH Shock Sensor & Prewarn Bypass: 1) Arm the alarm by, Pressing &...
-
Página 4: Owner's Guide Arming The System
Arming the Alarm The system may be “Armed” by any of 3 methods: Remote Control Arming: Press & Release the “Lock” button THE SIREN WILL CHIRP ONCE THE PARKING LIGHTS WILL FLASH ONCE THE DOORS WILL LOCK (IF CONNECTED) 2) SILENT Remote Control Arming: Press &... -
Página 5: Disarming The Alarm
Disarming the Alarm The system may be “Disarmed” by any of 3 methods: Remote Control Disarming: Press & Release the “Unlock” button THE SIREN WILL THE PARKING LIGHTS CHIRP TWICE WILL FLASH TWICE THE DOORS WILL UNLOCK (IF CONNECTED) 2) SILENT Remote Control Disarming: Press &... -
Página 6: System Armed & Activated
System Armed & Activated Regardless of method used to Arm the alarm, once Armed, the alarm will monitor all protected zones, and if an intrusion attempt is detected it will activate, or “trigger”. A trigger consists of the following: • The electronic siren, or optionally the vehicle’s horn, will start sounding. •... -
Página 7: Auxiliary Channel
The Auxiliary Channel The Auxiliary Channel may be used to operate an optional function. Pos- sibilities include remote trunk release, remote car starting, or an on-demand remote window roll-up interface. Please see your Omega dealer for details on available options. To Activate the Auxiliary Channel: Press &... -
Página 8: Anti-Carjacking
Programmable Anti-Carjacking Protection The Anti-Carjacking sequence may be activated by any of 3 methods: 1) Using the remote control, by holding down the Small “4th” Button for 3 seconds while the ignition is “On”. (programmable feature 2) When a door is Opened while the ignition is “On” (programmable feature 3) Every time the ignition is turned “On”. -
Página 9: Valet Mode
Valet Mode Valet Mode can only be entered into while the alarm is Disarmed. Valet Mode turns off all of the alarm’s security features, (including Anti-Carjack). Valet Mode is designed for situations in which it is not convenient for the security portion of the alarm to be operational;... -
Página 10: Auxiliary Sensor & Prewarn
Auxiliary Sensor & Prewarning Auxiliary Sensor: This security system is equipped with a plug-in port for an optional sensor to increase the effectiveness of the system. The comprehensive line of optional sensors offered is comprised of impact sensors, glass tampering sensors, and microwave/radar sensors which can detect motion inside and outside the vehicle. -
Página 11: How To Program Features
How to Program Features To access Features Programming Mode: Step 1: Turn the vehicle’s ignition “On” then “Off”. Step 2: Within 7 seconds of turning the ignition “Off”, press the Valet Switch 5 times. The siren will wolf once confirming entry to Features Programming Mode. - Página 12 4. Double Pulse Unlock: ( 2 pulses = 1 siren chirp / • 1 pulse = 2 chirps) - Sets alarm to give 2 unlock pulses upon Disarm for cars that require it. 5. Immobilizer Mode: ( On = 1 siren chirp / •Off = 2 chirps) - If this mode is programmed “On”, the starter interrupt will remain engaged after the alarm is Disarmed, until the vehicle’s ignition is turned “On”...
- Página 13 11. Dome-Light or Window Roll-Up: (•Dome-Light = 1 siren chirp / Window Roll-UP = 2 chirps) - Configures the alarm’s “Black/White” wire to operate the: a. Dome-Light: Supply a (-) output when the alarm is Disarmed to illuminate the vehicle’s Dome-Light for 30 seconds through the use of a relay, or b.
-
Página 14: "Rfid" Anti-Hijacking
“RFID” ANTI-HIJACKING (Programmable Feature #14) This feature requires the use of the #410-01 RFID Remote. (Sold separately) 1) To turn “On” the remote control’s RFID function: Press & Hold the remote’s button for 5 seconds, the LED will flash to confirm the RFID function is “On”... -
Página 15: Important
“RFID” Anti-Hijacking : (Programmable Feature #14) For the RFID remote control to operate with the alarm, it is necessary to pro- gram the remote to the alarm and turn “On” programmable feature #14. If programmable feature #14 is “On”, the Anti-Hijacking operation will commence every time: 1) The vehicle’s ignition is turned “On”... - Página 16 “RFID” Anti-Hijacking Operation : 1) The RFID Anti-Hijacking process is activated every time the vehicle’s igni- tion is turned “On”, or a vehicle door is opened while the ignition is “On”. 2) Upon activation, the alarm will begin to search for the RFID remote con- trol’s signal for 3 minutes.
-
Página 17: Wiring Diagram
Door Lock/Unlock pulse lengths: Jumper “ON” 0.80 Sec Jumper “OFF” 4.0 Sec Combined: SS-2 LED Status Indicator Valet/Override Button NOTE: requires a 5/16” (8mm) hole to be drilled Sensor • Main Wire Harness (H-AL16A) • Conector Central Battery Page 16... -
Página 18: Door Locking Systems / Sistemas De Cierre
Door Locking Systems / Sistemas De Cierre Negative Trigger System / Sistema Negativo: Doorlock Actuators Blue Green Unlock wire/ Cable de Apertura Lock wire / Cable de cierre Unlock Ground Lock Vehicle’s Doorlock Relay Control Unit Doorlock Switch Positive Trigger System / Sistema Positivo: Doorlock Actuators Blue...