System Armed & Activated; Remote Panic Operation; Panic; Sensor By-Pass - Excalibur AL-560 Guía De Installación

Regardless of method used to Arm the alarm, once Armed, the alarm will monitor
all protected zones, and if an intrusion attempt is detected it will activate, or
"trigger".
A trigger consists of the following:
• The electronic siren, or optionally the vehicle's horn, will start sounding.
• The exterior parking lights will fl ash on and off repeatedly.
An activation has a 30 second duration unless the system is disarmed using the
remote control or the Valet /Override switch. If all protected zones are secure
at the end of the trigger, the system will stop and rearm itself to detect further
entry attempts. If a protected zone is still open at the end of the trigger cycle,
the alarm will continue to re-trigger itself for up to six activated cycles before it
resets itself and ignores the violated zone.
Should it be needed in a threatening situation, or you feel the need to attract at-
tention, the alarm can be triggered using the remote control. Your alarm features
"Panic Mode", which allows you to activate "Panic" from the "Arm/Lock" button.
To Activate Remote Panic:
Hold 3 seconds
The shock sensor & Prewarn zone can be by-passed using the remote
control. This may be useful in stormy weather.
1) Arm the alarm by, Pressing & Releasing the "Lock" button.
2) Within 2 seconds, Press & Release the
- The siren will chirp once to confi rm sensor has been by-passed.
- Upon Disarming the alarm, the sensor zone will reset.
System Armed & Activated

Remote Panic Operation

Press & Hold the "Arm/Lock" Button,
for 3 seconds, with the ignition "Off".
THE SIREN WILL SOUND

Sensor By-pass

.
1
Then
Page 5
THE PARKING LIGHTS
WILL FLASH
button.
"3rd"
2.