Installation - HAMPTON BAY 82056-055SR Guía De Uso Y Cuidado

Installation

1
Installing the solar panel
NOTE: Do not use a hammer. If the ground is hard, use water to
soften.
This step provides two options for installing the solar panel:
Ground installation and Mounted installation. Follow the
applicable steps below based upon your installation choice.
□ For ground installation, insert the ground stake (C) firmly into the
ground at the installation location. If the ground is too hard, soak
the ground with water to soften the ground or drive a metal rod or
screwdriver into the ground to create a hole for the ground stake
(C). Then connect the stake (B) to the ground stake (C).
For a mounted installation, install the wall mounting bracket (AA)
□
to the installation location using large mounting screws (BB). Then
connect the stake (B) to the mounting bracket (AA).
Connect the solar assembly (A) to the stake (B) and ensure the
□
solar panel is pointed towards the sun.
2
Installing the rope light
CAUTION: Do not submerse the rope light in liquids or use the
product in the vicinity of standing water.
NOTE: Prior to use, set the AUTO/OFF switch located on the
back of the solar box to the AUTO position and allow it to charge
a full sunny day.
NOTE: Approximately 6 feet of the first portion of your rope
light is non-illuminated lead wire only.
□ Use the small mounting screws (DD) to install the mounting clips
(CC) to a flat surface in the location where you would like to install
the rope light. Ensure the clips (CC) are evenly spaced about 2 feet
apart.
□ Attach the lighted rope to the fixed mounting clips (CC).
A
C
4
B
BB
AA