Installation Instructions - HAMPTON BAY 675-458 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLATION INSTRUCTIONS

(AS SHOWN IN DIAGRAM):
INSTALLATION OF TRACK/CONNECTOR ASSEMBLY:
1. Determine which connector will be used to power track and attach.
2. Place track power feed connector assembly at desired location on ceiling, noting
location of electrical supply. Mark the ceiling through the holes in track and remove
track.
3. For toggle bolt installation, drill a 5/8in. hole at each mark on ceiling, insert bolts
through the track and thread toggles 1/2in. onto bolts.
4. Place track/connector assembly against ceiling and insert toggles into holes until the
spring open. Tighten bolts.
5. To connect two tracks, loosen set screws on straight connector, align grounds and insert
into track. Tighten set screws.
Toggle bolt assy
TROUBLE SHOOTING:
Problem
Light
Bulb
will
not
illuminate.
Fuse
blows
or
circuit
breaker trips when light
bulb is illuminated.
Ceiling
Possible Cause
1. Light bulb is burned
out.
2. Power is off.
3. Faulty connection of
fixture to track or wire
connections.
4. Faulty switch.
Crossed wires or power
wire is grounding out.
4
Dead end cap
Track
Corrective Action
1. Replace light bulb.
2. Make sure power supply is
on.
3. Check connection of fixture
to track. Check wiring.
4. Test or replace switch.
Check wire connections.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

555-219008938275088008938275002

Tabla de contenido