Energy Saving Mode; Important - McDonald's 416-SS Serie Manual De Instrucciones

3. To cancel the set point programming mode at any
time, press and release the time button. The
display will change to show the actual platen
temperature. See figure 9.
figure 9
Programming Toast Times
1. Press and hold the time button for 6 seconds. A
beep will sound, and the time indicator light will
blink. Release the time button to show the
current toast time. See figure 10.
figure 10
2. Use the up and down arrow buttons to set your
desired toast time. The range is from 20 seconds
to 1 minute, 30 seconds. When desired time is
reached, press and release the time button to
store the new time. See figure 11.
figure 11
SETTING THE NEW TIME
STORING THE NEW TIME
2 1 5
5 5
3 5
3 5
7
3. To cancel the time set function at any time,
press and release the temperature button. The
time indicator light will turn off, and the display
will change to show the actual platen tempera-
ture. See figure 12.
figure 12

ENERGY SAVING MODE

To conserve energy during non-toasting periods, pull
the toaster handle down, so that the timing cycle
activates. When the audio alarm goes off, indicating
that the toasting time is complete, DO NOT pull the
handle up. Allow the audio alarm to sound until the
alarm shuts off, the display will alternately flash
Stand and By , indicating the toaster is in the
energy savings mode. The toaster platens will
continue to maintain the programmed operating
temperature, raising the toaster handle will put the
toaster back into the operation mode.
SETTING STOP BLOCKS
Stop blocks allow for proper crush when toasting
buns. The toaster leaves the factory with the stop
blocks set on number 3. The stop blocks are located
toward the front of the toaster on the right and left
sides of the base. To increase the crush, set the
stop blocks to the number 2 setting. To decrease
the crush, set the stop block to the number 4 set-
ting. See figure 13.
IMPORTANT: The stop blocks are set at the number
that is touching the lever. The example in figure 13
shows a stop block setting of 1.
1. To change the stop block setting, depress the
right stop block and disengage the locking pin.
Turn stop block to correct setting.
figure 13
STOP
BLOCK
SETTING
2 1 5