Cleaning; Troubleshooting - McDonald's 416-SS Serie Manual De Instrucciones

CLEANING

1. Press the power switch to the off position.
2. Unplug toaster.
3. Allow toaster and platens to cool down.
4. Wipe entire platen with clean, damp grill cloth.
Full toaster cleaning must be done in the morn-
ing when toaster is cold. See your Planned
Maintenance Card for proper cleaning procedures.
IMPORTANT: Do not drape cord over hot toaster bun
board or platen. This will cause cord to burn.
TROUBLESHOOTING GUIDE
PROBLEM
Platen loose.
Speaker sounds, but no
bun done light comes on.
No speaker sounds
and bun done light.
does not come on.
Buns being crushed.
Platen does not heat.
No Display.
CAUSE
Platen bolts loose.
Done light burned out.
Defective timer switch.
Timer connection shorted
on power board.
Timer switch not activating.
Stop blocks not adjusted
properly.
Warped bun trays.
Buns cut improperly.
No power.
Power switch defective.
Shorted power board.
Platen burned out or shorted.
Fuse Defective.
8
SOLUTION
Tighten platen bolts.
Replace done light.
Replace timer switch.
Replace power board.
Check actuating bracket to
make sure it pushes
timer switch all the way in.
Adjust stop blocks.
Straighten or replace bun
trays.
Contact bakery.
Check power source.
Replace power switch.
Replace power board.
Check platen with ohmmeter
for 11 ohms, if reading is less
than 7 ohms or more than 14
ohms, replace platen.
Check fuse with ohmmeter,
reading should be 1-2 ohms.