Publicidad
Idiomas disponibles
Idiomas disponibles
Paragraph 8 – Timed Dosage (Frequency signal input "TRIGGER" not activated)
Programming
PROG
Configuration
Configuration
Pum functions
-
+
Pum functions
Tempo
-
Time
-
Quantity
100ml
-
Time
g.hh.mm
-
Delay
0.01.50
-
Time
g.hh.mm
-
Interval
0.01.50
-
Trigger Mode
-
Disable
Pause Input Mode
Pause Input Mode
-
Restart Timer
Restart Timer
Pause Input Mode
Freeze Time
Pause Input Mode
Pause Dosing
Display during Operation
Operating mode
Timer
Alarms and Level
statuses = level alarm
Flow = flow alarm
Dry = pump starting up
Stop = pump stopping
Restart = pump restarting
Paragraph 9 – Setting the Maximum Flow
Programming
PROG
Pump Functions
-
Max flow rate
Max flow rate
P100%
P100%
-
Max flow rate
F320s/m
EM00136061
All manuals and user guides at all-guides.com
The pump doses a programmed quantity in ml. It is possible to set a
pump delay time (Delay) when the pump is started and an interval
between two successive dosings (Interval), as illustrated in the
diagram:
+
The Delay and Interval times are in dd.hh.mm (days, hours,
minutes)
+
The Pause input can be programmed in three different modes:
+
1. FreezeTime: when the pause is activated, the system cuts
+
2. Pause Dosing: with the pause activated, the system
3. Restart Timer: when the pause is activated, the system
-
The dosage frequency can be modified while the pump is operating,
-
by pressing the
frequency, or the
FLOW
Programmed value
Quantity in ml
sensor
status
Timer
F
F F
7.0 ml
Liv
Stop
P 0%
Value of dosing in
progress:
Percentage of
Pump status
-
+
-
-
+
-
rev. 2.5
Operation
Quantity
Delay
Interv.
out the current time count and restarts it when the pause is
deactivated.
continues to count time the and stops the dosing.
stops the dosing and when the pause is deactivated the
count starts again from the beginning.
keys at the same time to increase the
keys to decrease it.
Display at start-up (MODE key)
The following are shown in sequence:
quantity to dose, delay in d.hh.mm.
and interval in d.hh.mm
Q.tà
20,0ml
strokes/min max
Value of the dosing percentage,
which can be modified by
pressing the + or – keys
This makes it possible to set the maximum flow offered by
the pump, and the programmed mode (% or frequency) is
used as the standard unit of measurement when displaying
the flow. Changes can be made by pressing the
then using the
keys to set the new value. Press
to confirm and return to the main menu
EN
Operating mode
Dosing value
Programmed
20,0ml
P 100%
quantity in m
l
Operation
key,
8
Publicidad
