NSK Ti-Max M40-LED Manual Del Usuario página 4

(2) Disconnecting
Simply pull out the handpiece from the motor.
Care should be taken when using any handpiece attachment which requires lubrication. Following lubrication
stand the handpiece attachment vertically until the excess solution drains. Wipe the handpiece then attach it to
the motor. If oil enters to the motor, it may cause malfunction.
After each use, clean the surface of the motor with brush etc. ( Do not use the metal brush ) , and wipe it with the
cotton moistened with disinfecting alcohol.
4. Replace the O-rings at the Motor Insert
( 1 ) Remove the worn O-rings with a pointed tool like a needle.
( 2 ) Insert new O-rings the O-ring grooves.
Optional O-ring ( Blue ) : Order No. 0313 084070
Optional O-ring : Order No. 0312 074080
There are 4 O-Rings on the Motor Insert. Blue one is thinner
than other 3 pieces. Make sure to order it.