Cleaning The Machine - Krups XP4050 Instrucciones De Uso

• Put the auto cappucino accessory in place
on the steam nozzle.
• Place a cup under the auto cappuccino
accessory.
• Pour about 100 ml of cold milk into a
container.
• Insert the fl exible tube into this container
or directly in the milk (16a).
Please note the straight cut end of tube
must fi t inside auto cappuccino device and
irregular end dipped in the milk.
• Turn the setting knob on the auto
cappuccino accessory to the position
'cappuccino' or 'latte'.
• When the machine is ready (start/stop
switch glows continously), press the steam
button (15), and it will begin to blink.
When the steam button glows continuously
again, the machine is now ready for steam.
• Press the steam button
• Once the desired level of froth has been
produced, press the steam button again
to stop (15). The cool down cycle is
launched.
Follow this cleaning operation in order to
prevent the milk from drying on the auto
cappuccino accessory:
• Place a cup under the auto cappuccino
accessory.
• Immerse the fl exible tube into a clean
container 1/3 full of water.
• Press the steam button
all the water has run through, press the
steam button again
• Cappuccino accessory has to be cleaned
properly after each use with milk. Please
refer to the section below entitled «Clea-
ning the machine».
. Using the perfect froth accessory as
an alternative to the auto cappuccino
accesssory.
• Replace the auto cappuccino accessory
with the perfect froth accessory.
Fill the water container with fresh, cold
•
water (1) (2) (3) and turn on the machine
(4).
• When the machine is ready (start/stop
switch glows continuously), press the
12
(15).
(15) and when
(15) to stop.
steam button (15), and the start/stop
switch will begin to blink.
When the steam button glows continuously
again, the machine is ready for steam.
Immerse the perfect froth accessory in the
•
milk to be heated (we recommend that a
stainless steel container with a capacity of
about 0,5 litres be used).(16b)
Hold the container under the perfect froth
•
accessory in such a way that the tip is
immersed in the milk.
Press the steam button
•
container steady during this operation. Do
not allow the tip of the perfect froth acces-
sory to touch the bottom of the container
as this will obstruct the steam output.
• Once the desired level of froth has been
produced, press the steam button
again to stop.
Follow this cleaning operation in order to
prevent the milk from drying on the auto
cappuccino accessory:
• Submerge the perfect froth accessory in a
container with water.
• Press the steam button
all the water has run through, press the
steam button again
Wipe the perfect froth accessory with a
•
damp cloth.

Cleaning the Machine

Cleaning the Machine
- Never wash your espresso machine
accessories in the dishwasher.
After use, the water tank must be emptied.
. Drip tray
If several espressos are being prepared
one after the other, the drip tray should be
emptied from time to time (about once every
 - 8 espressos) (18). The presence of water
is normal and does not signify a leak. If
necessary, clean the drip tray and its grid
with water and a little non-abrasive washing-
up liquid, rinse and dry. Replace it correctly
(19).
. The brewing head, the fi lter and the fi lter
holder
These must be cleaned after each use. All
(15). Keep the
(15)
(15) and when
(15) to stop.