Installing The Light Kit; Installing The Battery - Progress Lighting AIRPRO P2582 Manual De Instalación

Before starting
CAUTION:
disconnect the power by turning off the circuit
breaker or removing the fuse at fuse box. Turning
power off using the fan switch is not sufficient to
prevent electric shock.
Step 1. Remove the 1 of 3 screws from the posts
of the mounting plate and keep it for future use.
Loosen the other 2 screws. (Do not remove) (Fig.
17)
Step 2. While holding the LED light kit under
your fan, make the polarized plug connections:
- White to white
- Black to blue
Step 3. Place the key holes in the LED light kit
over the two screws previously loosened from the
mounting plate. Turn the LED light kit until the
LED light kit locks in place at the narrow section
of the key holes. (Fig. 17)
Step 4. Securely tighten the two light kit
mounting screws previously loosened and the one
previously removed. (Fig. 17)
Step 5. Raise glass shade up against the LED
light kit, and secure it to fan by turning light kit
shade clockwise until snug.
OVERTIGHTEN. (Fig. 17)
9.

Installing the Light Kit

installation,
Wire connector
LED
Light kit
Glass
shade
Figure 17
DO NOT

Installing the battery

Install 12V battery (included), to prevent damage to
transmitter, remove the battery if not used for long
periods.
Mounting
plate
Screws
Figure 18