Hanging The Fan - Progress Lighting AIRPRO P2582 Manual De Instalación

Hanging the Fan

REMEMBER to turn off the power. Follow
the steps below to hang your fan properly:
Step 1. Remove the decorative canopy bottom
cover from the canopy by turning the cover
counter clockwise.(Fig. 8)
Step 2. Remove the mounting bracket from
the canopy by removing the 1 of 2 screws
from the bottom of the mounting bracket and
loosening the other one a half turn from the
screw head. Next, turn the canopy counter
clockwise to removing the mounting bracket
from the canopy. (Fig. 8)
Step 3. Pass the 120-volt supply wires
through the center hole in the ceiling hanger
bracket as shown in Fig. 9.
Step 4. Secure the hanger bracket to the
ceiling outlet box with the screws and
washers provided with your outlet box.
Step 5. Remove the hanger pin, lock pin and
set screws from the top of the motor
assembly.
Step 6. Route wires exiting from the top of
the fan motor through the coupling cover,
canopy cover, canopy and then through the
ball / downrod. (Fig. 10)
5.
Step 7. Align the holes at the bottom of the downrod
with the holes in the collar on top of the motor
housing (Fig. 10). Carefully insert the hanger pin
through the holes in the collar and downrod. Be
careful not to jam the pin against the wiring inside the
downrod. Insert the locking pin through the hole near
the end of the hanger pin until it snaps into its locked
position, as noted in the circle inset of Fig. 10.
WARNING
FAILURE TO PROPERLY INSTALL
LOCKING PIN AS NOTED IN STEP 7
COULD RESULT IN FAN LOOSENING AND
POSSIBLY FALLING.
Step 8. Tighten two set screws on top of the fan
motor firmly. (Figure 10)
Step 9. Place the downrod ball into the hanger
bracket socket.
Figure 8
UL Listed
electrical
box
Ceiling
hanger
bracket
Hook
Figure 9
Motor wires
Ball/downrod
assembly
Canopy
Canopy cover
Coupling cover
Ceiling
hanger
bracket
Hanger pin
Ceiling
canopy
Figure 10
Canopy
cover
Washers
Mounting
screws
(supplied with
120V Wires
electrical box)
Pin in locked
positioon
Tighten screw
firmly
Lock pin