Cooper Lighting SP125 Instrucciones

SP125
ENGLISH
ITEMS REQUIRED
(Purchase separately)
• 150 watt (max.) PAR 38 flood bulb
NOTE: This fixture was designed to use up to a 150 watt bulb. For improved energy efficiency,
use lower wattage PAR flood bulbs.
WARNINGS AND CAUTIONS
• IMPORTANT: READ ALL SAFETY INSTRUCTIONS.
• For outdoor use only.
• cULus LISTED for wet location use.
• Connect fixture to a 120 volt, 60 Hz power source. Any other connection voids the warranty.
• Use with only three-wire extension cords that have three-prong grounding plugs and that
are suitable for outdoor use, such as cords marked SW, SW-A, SOW, SOW-A, STW, STW-A,
STOW, STOW-A, SJW, SJW-A, SJOW, SJOW-A, SJTW, SJTW-A, SJTOW, SJTOW-A and
grounding receptacles that accept a three-prong plug. When the fixture is used in wet
locations, provide Ground Fault Circuit Interruption (GFCI) protection on the circuit(s) or
outlet(s) to be used.
• Risk of fire/electric shock. Do not use with extension cord near water or where water may
accumulate. Keep lamp at least 16 feet from pools and spas. Keep plugs and receptacles
dry. For use only on GFCI protected circuits.
• Bulb gets HOT quickly!
• The bulb and fixture get extremely hot during use. Disconnect power and allow fixture to
cool before changing bulb, repositioning fixture or handling fixture.
• Always replace bulb with the same wattage or lower wattage than marked. Installing a bulb
of a higher wattage could create a fire hazard. Use of a higher wattage bulb will void the
warranty. Only use a 120 volt bulb.
• Keep lamp away from materials that burn. Do not position fixture within
two inches of any combustible materials.
• Do not use this apparatus near water.
• Clean only with a dry cloth.
• Do not block any ventilation openings. Install in accordance with the manufacturer's
instructions.
• Only use attachments/accessories specified by the manufacturer.
• Disassembling your fixture will void the warranty.
• Your fixture is pre-wired and pre-assembled for easy installation.
• To avoid a hazard to children, account for all parts and destroy all packing materials.
• Note: Deviation from the assembly instructions may result in a risk of fire or electric shock.
• SAVE THESE INSTRUCTIONS.
INSTALLING YOUR FIXTURE
NOTE: Be sure to aim the light in the desired directions left or right) before inserting the
spike (B) into the ground.
Questions? / ¿Preguntas ? 1-800-334-6871 ConsumerProducts@cooperlighting.com
PACKAGING CONTENTS / CONTENIDO DEL PAQUETE
A. Fixture assembly B. Spike
Luminaria
C. Gasket
Pico Junta
1. To position fixture in the ground, hold the fixture by the cone-shaped section of housing
located between the spike (B) and the fixture head and push spike (B) straight down
into the ground.
2. Insert threaded end of bulb through gasket (C).
3. Screw PAR 38 flood bulb (sold separately) into fixture.
NOTE: Bulb cannot exceed 150 watt maximum wattage. This fixture was designed to use up
to 150 watt bulbs. For improved energy efficiency, lower wattage PAR flood bulbs can be used.
4. Plug power cord into grounded three-prong receptacle or into three-prong grounded
extension cord (see the "Warnings and Cautions" section for approved types of
extension cords).
AIMING THE LIGHT
1. Loosen the knob on the side of the light housing. Tilt fixture head up or down to desired
position; retighten knob.
NOTE: Do not aim the lamp head vertically.
2-YEAR LIMITED WARRANTY
THE FOLLOWING WARRANTY IS EXCLUSIVE AND IN LIEU OF ALL OTHER WARRANTIES,
WHETHER EXPRESS, IMPLIED OR STATUTORY INCLUDING, BUT NOT LIMITED TO, ANY
WARRANTY OF MERCHANTABILITY OR FITNESS FOR ANY PARTICULAR PURPOSE.
Cooper Lighting, LLC ("Cooper Lighting") warrants to customers that, for a period of two years
from the date of purchase, Cooper Lighting's products will be free from defects in materials
and workmanship. The obligation of Cooper Lighting under this warranty is expressly limited
to the provision of replacement products. This warranty is extended only to the original
purchaser of the product. A purchaser's receipt or other proof of date of original purchase
acceptable to Cooper Lighting. This is required before warranty performance shall
be rendered.
This warranty does not apply to Cooper Lighting products that have been altered or repaired or
that have been subjected to neglect, abuse, misuse or accident (including shipping damages).
This warranty does not apply to products not manufactured by Cooper Lighting which have
been supplied, installed, and/or used in conjunction with Cooper Lighting products. Damage to
the product caused by replacement bulbs or corrosion or discoloration of brass components
are not covered by this warranty.
LIMITATION OF LIABILITY:
IN NO EVENT SHALL COOPER LIGHTING BE LIABLE FOR SPECIAL, INDIRECT, INCIDENTAL,
OR CONSEQUENTIAL DAMAGES (REGARDLESS OF THE FORM OF ACTION, WHETHER IN
CONTRACT, STRICT LIABILITY, OR IN TORT INCLUDING NEGLIGENCE), NOR FOR LOST PROFITS;
NOR SHALL THE LIABILITY OF COOPER LIGHTING FOR ANY CLAIMS OR DAMAGE ARISING
OUT OF OR CONNECTED WITH THESE TERMS OR THE MANUFACTURE, SALE, DELIVERY, USE,
MAINTENANCE, REPAIR OR MODIFICATION OF COOPER LIGHTING PRODUCTS, OR SUPPLY OF
ANY REPLACEMENT PARTS THEREFORE, EXCEED THE PURCHASE PRICE OF COOPER LIGHTING
PRODUCTS GIVING RISE TO A CLAIM. NO LABOR CHARGES WILL BE ACCEPTED TO REMOVE
OR INSTALL FIXTURES.
To obtain warranty service, please contact Cooper Lighting, LLC, at 1-800-334-6871, press
option 2 for Customer Service, or via e-mail ConsumerProducts@cooperlighting.com and
include the following information:
1
Instruction Manual/ Instrucciones