Publicidad
®
™
REESE
Elite
TOOLS
Safety Glasses
Impact Wrench
1-1/8" Socket
1.
Check all the boxes for all the components listed in
2.
For cutting pattern and rail installation refer to 30868N Instructions for Chevy applications OR 30852N
Instructions for Dodge applications.
3.
Place the REESE
3/4" conical washers(2), slide them into place through the slots found in the Gooseneck center
section(1).
4.
Slide the gooseneck center section up around the holes found on the bottom of the Rails and loosely assemble
the hardware. Repeat this process for the remaining 3 bolts. DO NOT TIGHTEN THE HARDWARE AT THIS
TIME.
5 .
Once the REESE
was cut in step 2.
6.
Once the top of the gooseneck receiver tube is located in the hole (See figure 8), then tighten the hardware to a
torque of 180 ft/lbs, then the safety chains holder (see instruction manual for installation instructions) and 2-5/16"
hitch ball may installed.
Vehicle Forward
Installed safety chain holders
in truck bed.
30158N – 8/10/2011 REV C
GOOSENECK ASSEMBLY
®
Elite
™
Gooseneck Hitch under the truck (As shown in figure 7) using the 3/4" hex bolts(3) and
1
2
3
Gooseneck Hitch has been loosely assembled , locate the collar in the 3-1/2" hole that
®
™
Elite
PCN15852
3-1/2" Hole Saw
Torque Wrench
Figure 1
and become familiar with component terminology.
Vehicle Forward
©2011 CEQUENT PERFORMANCE PRODUCTS, INC.
Fig. 7
Installed gooseneck in
truck bed.
Fig. 8
Printed in XXXX
5
Publicidad
