Ty Pennington STYLE 146.46371610 Guía De Uso Y Cuidado página 10

Step 1:
1
Note: Please make sure to attach king post (E) in correct direction
as shown in bellow fig. otherwise the heater control panel will not
be facing in the direction of the front of the heater which is where
the door of cylinder housing is located .
Attach king-post (E) to cylinder housing (G) top. Open the door,
place king-post through the hole on the top of cylinder housing.
Attach king-post to cylinder housing top as shown with (4) bolts
pre-attached, (4) M6 flat washers and (4) M6 nuts , fully tighten
the nuts with provided wrench.
M6 flat washer, Qty: 4 pcs
pre-attached bolt
E
G
M6 nut, Qty: 4 pcs
10
King-post assembly: Please
attach the king post as shown
with sticker marked (Back)
facing the rear of cylinder
housing.