Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
English
Adjusting Torque Control (Fig. E)
•
This tool is fitted with a torque adjustment collar
select the operating mode and to set the torque for
tightening screws. Large screws and hard workpiece
materials require a higher torque setting than small
screws and soft workpiece materials.
•
For drilling in wood, metal and plastics, set the collar to
the drilling position symbol
•
For screwdriving, set the collar to the desired setting. If
you do not yet know the appropriate setting, proceed
as follows:
-
Set the collar to the lowest torque setting.
-
Tighten the first screw.
-
If the clutch ratchets before the desired result
is achieved, increase the collar setting and
continue tightening the screw. Repeat until you
reach the correct setting. Use this setting for the
remaining screws.
Fig. E
3
Dual Range Gearing (Fig. F)
The dual range feature of your drill allows you to shift gears
for greater versatility.
•
To select low speed, high torque setting (position 1),
turn tool off and permit to stop. Slide gear shifter
button
4
away from the chuck.
•
To select the high speed, low torque setting (position 2),
turn tool off and permit to stop. Slide gear shifter button
back toward the chuck.
nOTE: Do not change gears when tool is running. If you
are having trouble changing gears, make sure that the dual
range gear button is either completely pushed forward or
completely pushed back.
Fig. F
4
8
Keyless Chuck (Fig. G)
WARNING: Make certain the battery pack is
to
3
removed to prevent tool actuation before
installing or removing accessories.
To insert a drill bit or other accessory:
1. Grasp the chuck
direction, as viewed from the chuck end.
2. Insert the bit or other accessory fully into the chuck, and
tighten securely by rotating the chuck in the clockwise
direction as viewed from the chuck end.
WARNING: Do not attempt to tighten or loosen drill
bits (or any other accessory) by gripping the front
part of the chuck and turning the tool on. Damage
to the chuck and personal injury may occur when
changing accessories.
Fig. G
OPERATION
WARNING: To reduce the risk of serious personal
injury, turn unit off and and remove the battery
pack before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
Screw Driving
•
For driving fasteners, the forward/reverse button should
be pushed to the left.
•
Use reverse (button pushed to the right) for
removing fasteners.
nOTE: When moving from forward to reverse, or vice versa,
always release the trigger switch first.
Drilling
•
Use sharp drill bits only.
•
Support and secure work properly, as instructed in the
Safety Instructions.
•
Use appropriate and required safety equipment, as
instructed in the Safety Instructions.
•
Secure and maintain work area, as instructed in the
Safety Instructions.
•
Run the drill very slowly, using light pressure, until the
hole is started enough to keep the drill bit from slipping
out of it.
•
Apply pressure in a straight line with the bit. Use enough
pressure to keep the bit biting but not so much as to stall
the motor or deflect the bit.
5
and rotate it in the counterclockwise
5
Publicidad
Tabla de contenido
Solución de problemas
