Measuring Procedure - Beta 1760/TC2 Manual De Usuario

MEASURING PROCEDURE

Photo measurmnent
1 Apply a refl ective mark to the object being measured. Slide the function switch to "rpm photo"
position.
2 Depress the MEASURE BUTTON and align the visible light beam with the applied target. Verify
that the MONITOR INDICATOR lights when the target aligns with the beam.
Contact tach measurement
1 Slide the FUNCTION SWITCH to "rpm contact" position. Install the proper RPM ADAPTER
on the SHAFT.
2 Depress the MEASURING BUTTON and lightly pressing the RPM ADAPTER against the
center hole of rotating shaft. Be certain to keep alignment straight. Release the MEASURING
BUTTON when the display reading stabilizes.
Surface speed measurement
1 Slide the FUNCTION SWITCH to "m/min contact" position. Install the SURFACE SPEED
WHEEL on the SHAFT instead of the RPM ADAPTER.
2 Depress the MEASURING BUTTON and simply attaching the SURFACE SPEED WHEEL to
the detector. Release the MEASURING BUTTON when the display reading stabilizes.
7