Worx HYDROSHOT WG644 Manual De Instrucciones página 14

Start
NOTE: At the first use, you need to
empty the air in hose, place the
power nozzle below waist level
(<5ft/1.5m), then attach the pressure
cleaning lance and set it at high
pressure. It does not start working
until the water goes up along the hose
and sprays out. This could take up to
30 seconds or more depending on the
fresh water source.
NOTE: If air builds up within the hose
or pump, the water pressure will drop.
First, restart the machine, then air will
be released through the multi-spray
nozzle along with any excess water.
Cleaning
WARNING: Do not connect the
machine to water supplies that are
dirty, rusty, muddy, or corrosive.
(Including window cleaning liquids, plant
foods, or fertilizers etc.)
NOTE: It is recommended to use the
high pressure mode for cleaning.
Not recommended for use with salt
water, immediately rinse with fresh
water for proper maintenance.
BATTERY STATUS (See Fig. F)
Before starting or after use, press the button beside
14
the power indicator light on the machine to check the
battery capacity. During operation, the battery capacity
will be indicated automatically by the battery power
indicator.
The indicator constantly senses and displays the
battery condition as follows.
For a machine with 2 battery packs with different
power levels, the power indicator light displays the
battery condition with the lower power level of the two
batteries.
Battery power
indicator status
Five green lights
( ) are
illuminated.
Two, three or four
green lights are
illuminated.
Only one green light
( ) is
illuminated.
No light is
illuminated.
Cordless Portable Power Cleaner
See Fig. I
See Fig. J
Battery condition
The two batteries are in a
highly charged condition.
The two batteries have a
remaining charge. The more
lights are illuminated, the
more battery capacity.
The battery level of at
least one battery pack is
very low. Please check and
charge the battery pack.
At least one battery is not
fully installed or battery
may be defective.
Only one light is
flashing twice per
cycle.
Only one light is
flashing three times
per cycle.
Only one light is
flashing four times
per cycle.
ATTACHMENT OF
ACCESSORIES
A number of accessories have been supplied with
this product and are required for use in different
applications. Do not attempt to use the cleaner
with no lance or accessories attached.
1. Soap bottle (WA4036, sold separately)
Soap bottle provides detergent suds for deeper
cleaning of dirt. It is used in conjunction with power
nozzle or extension lance (WA4012). (See Fig. K, L)
NOTE: Make sure the machine is connected to the
water source before using the soap bottle.
2. Brush (WA4048, sold separately)
Brush is for cleaning cars, boats, motorcycles
etc. It is used in conjunction with power nozzle or
extension lance (WA4012). (See Fig. M1, M2)
3. Window squeegee with water sprayer
(WA4050, sold separately)
The window squeegees quick connection easily
snaps into the tool to spray water or wipe off
water from glass or tiled surfaces. Suitable for the
HYDROSHOT power cleaner or extension lance
TM
(WA4012). (See Fig. N1-N4)
4. Bottle cap connector (WA4038, sold
separately)
The bottle cap connector accessory allows the tool
to directly connect with most 2 Liter bottles with
approximately 1" openings. (NOTE: May not fit
all consumable soda and water bottles) (See Fig.
O1-O3)
WARNING: Do not install the bottle cap
connector accessory until it is ready to be used.
The accessories vents will leak liquid, if a bottle is
installed, with the machine lying on a surface.
5. Turbo nozzle (WA4037, sold separately)
The turbo nozzle delivers 360° of rotating water,
which cleans a larger area than the 0° water
pattern during the same time period. Suitable
with the pressure cleaning lance installed on the
At least one battery is
over discharged (please
refer to the battery charge
condition), please recharge
the two batteries at once
before use again or storage.
At least one battery is hot,
wait for them cool down
before start again.
The machine is over load.
EN