Transmitting - Kenwood Nexedge NX-700 Manual De Instrucciones

TRANSMITTING

For Trunking channels, refer to "Making Group Calls (Digital)" and "Making
Individual Calls (Digital)", below.
1 Select the desired zone and channel using the Zone Up/ Zone Down or
CH/GID Up/ CH/GID Down keys.
2 Press the key programmed as Monitor or Squelch Off to check whether or
not the channel is free.
• If the channel is busy, wait until it becomes free.
3 Press the microphone PTT switch and speak into the microphone. Release
the PTT switch to receive.
• The LED indicator lights red while transmitting and green while receiving a signal.
This indicator can also be disabled by your dealer.
• For best sound quality, hold the microphone approximately 1.5 inches (3 ~ 4 cm)
from your mouth.
■ Making Group Calls (Digital)
If a key has been programmed with Group or Group + Status, you can select
a group ID from the list to make a call to those parties. To select a group ID:
1 Press the key programmed as Group or Group + Status.
2 Press the
pre-entered into your transceiver.
• The target group ID/name appears on the display.
• If you are using a microphone keypad, you can enter a unit ID by pressing the
DTMF keypad.
3 Press and hold the microphone PTT switch to make the call.
• Speak into the microphone as you would during a normal transmission.
■ Making Individual Calls (Digital)
If a key has been programmed with Individual or Individual + Status, you can
make calls to specifi ed persons.
1 Press the key programmed as Individual or Individual + Status.
2 Press the
pre-entered into your transceiver.
• The target unit ID/name appears on the display.
• If you are using a microphone keypad, you can enter a unit ID by pressing the
DTMF keypad.
3 Press and hold the microphone PTT switch to make the call.
• Speak into the microphone as you would during a normal transmission.
10
/ keys to select a group ID/name from the list that has been
/ keys to select a unit ID/name from the list that has been