Synchronising The Controller With The Remote Transmitter - Carson MODEL SPORT DRAGSTER SHOOTER 6SL Instrucciones

2. Synchronising the Controller with the
Remote Transmitter
• Switch on the transmitter.
• Connect the controller to the power supply.
• Hold down the SET button and switch the controller on at the on/off
GB
switch; you will hear a beep.
The blue LED lights up.
• Set the throttle/brake lever to the full acceleration position.
The red and yellow LED lamps flash briefly and then remain illuminated.
You will hear a beep.
The full throttle setting is stored.
• Return the throttle/brake lever fully.
The yellow and blue LED lamps flash briefly and then remain
illuminated. You will hear two beeps.
The brake setting is stored.
• Put the throttle/brake lever to neutral.
The red and green LED lamps flash briefly and then remain illuminated.
You will hear three beeps.
• The synchronization is complete, all LEDs are off.
• Switch the controller off.
When you switch the controller on again, the speed controller is
synchronized to the transmitter and is fundamentally ready for use.
28 CARSON DRAGSTER Brushless Controller