Setting The Drag Brake (Engine Brake) - Carson MODEL SPORT DRAGSTER SHOOTER 6SL Instrucciones

11. Setting the Drag Brake (Engine Brake)

The drag brake simulates the friction of the brushes of brush motors.
Flashing
frequency
Drag
brake (%)
GB
• Press the SET button down until the blue and yellow LEDs light up.
Release the SET button again.
• The blue and yellow LEDs start flashing. This shows that you are in the
mode for setting the parking brake.
• Press the SET button repeatedly until you reach the required setting.
The blue and yellow LEDs flash at the next highest speed.
• By repeatedly pressing briefly on the SET button you can scroll through
the settings.
• When you reach the required setting, hold down the SET button for
approx. 2 seconds; the setting is stored.
• Once you have stored the setting, the status LEDs flash one after
the other to show that you are leaving the programming mode. The
controller is ready for operation again.
• If you do not press the SET button for more than 10 seconds the
controller reverts to the last setting and is ready for use again.
36
1 2 3
OFF 5 10
CARSON DRAGSTER Brushless Controller
4 5 6
15 20 25
7 8 9
30 35 40
10
45