Selecting A Pre-Programmed Driver Profiles (Throttle/Brake Settings) - Carson MODEL SPORT DRAGSTER SHOOTER 6SL Instrucciones

13. Selecting a Pre-programmed driver Profiles
(Throttle/Brake Settings)
Profiles 1 - 4 have no influence on the undervoltage protection set at the
time when you selected the type of battery.
Driver profile
GB
Cut-Off
Reverse travel
Percentage
reverse travel
Maximum
braking
performance
Parking brake
Dead Band
• Press the SET button down until all of the LEDs light up. Release the SET
button again.
• All LEDs start flashing. This shows that you are in the mode for setting
the driver profile.
• Press the SET button repeatedly until you reach the required setting. All
LEDs flash at the next highest speed.
• By repeatedly pressing briefly on the SET button you can scroll through
the settings.
• When you reach the required setting, hold down the SET button for
approx. 2 seconds; the setting is stored.
• Once you have stored the setting, the status LEDs flash one after
the other to show that you are leaving the programming mode. The
controller is ready for operation again.
• If you do not press the SET button for more than 10 seconds the
controller reverts to the last setting and is ready for use again.
38
1 2
as as
selected selected
no yes
0 50
30% 30%
15% 10%
3 3
CARSON DRAGSTER Brushless Controller
3 4
as as
selected selected
yes no
50 0
40% 40%
15% -
4 4
reset to 5
factory
defaults
NiMH
yes
25
30%
10%
3