Installing Adapter Brackets To Screen - PEERLESS SUA746PU Instalación Y Montaje

Installing Adapter Brackets to Screen

• Tighten screws so screen brackets are firmly attached to screen. Do not tighten with excessive force. Overtightening
can cause stress damage to screws, greatly reducing their holding power and possibly causing screw heads to
become detached. Tighten to 40 in. • lb (4.5 N.M.) maximum torque.
• If screws don't get three complete turns in the screen inserts or if screws bottom out and bracket is still not tightly
secured, damage may occur to screen or product may fail.
To prevent scratching the screen, set a cloth on a flat, level surface that will support the weight of the screen. Place
2
screen face side down. If screen has obstructions on the back, remove them to allow the adapter brackets to be
attached. Place adapter brackets (B) on back of screen, align to holes, and center vertically on back of screen as
shown below. Attach the adapter brackets to the back of the screen using the appropriate combination of screws,
washers, and spacers, if required, as shown in steps 2-1 or 2-2.
NOTE: Top and bottom holes must always be used.
Verify that all holes are properly aligned, and then tighten screws using allen wrench (G).
NOTE: For flat back screens proceed to step 2-1. For bump-out or recessed back screen skip to step 2-2.
WARNING
B
CENTER BRACKETS
VERTICALLY
ON BACK OF
SCREEN
NOTE: "X" dimensions should be equal.
6 of 42
X
NOTE: LATCHES
INDICATED BOTTOM
OF BRACKETS (B).
X
ISSUED: 12-01-09 SHEET #: 095-9295-2 01-23-10