Routine Cleaning; Cleaning The Air Filter - Ecodryer Blade Manual De Instrucciones

Routine Cleaning

Cleaning the Unit body
Before it gets obviously dirty
Clean the unit with a soft cloth.
If the unit gets very dirty, clean with a soft cloth dampened with neutral
agent, then clean with a dry soft cloth.
Remove the dirt from the sensor. (to prevent malfunction)
Only use the neutral cleaning agents.
Do not use thinner, acidic or alkaline toilet cleaners, or nylon
brush. (Otherwise, they may damage the smoothness of
surface)
Only use the alcohol to clean the U-shaped groove(hand
Note -drying area).(Do not use alcohol anywhere else)
Alcohol here means the alcohol used for disinfection
(concentration under 83%).
If you use a chemical cloth, please read instruction first.
Desinfecting agents will damage your unit.
Draining and Cleaning the drain tank
Before it fills up (at least once a week)
The water blown off the hands is called
Empty the drain water at any moment, in order to prevent
accumulated water from exceeding the full level.
It will start smelling if the accumulated water remains in
the tank for too long time.
Pull the drain tank out in the
horizontal direction.
1
This ensures the drain water
does not splatter out.
Open the cover and empty
the water.
Pull the cover up with your fingers
in the direction of the arrow on top
of the cover, and then remove the
cover completely.
Wash out the interior of the
drain tank.
2
Close the water tank cover, and
Re-attach it to the unit as originaly.
Pay attention that the two locations
are firmly inserted.
If you wash the air filter with water,
and dry it as much as possible.
Do not expose to the fire.
If the machine is equipped with HEPA
Note
filter,please be sure to replace the filter every 6
months at least to prevent the air duct is blocked.
drain water .
Full level
Drain tank
Cover
Cover
Full level
Use the specific screwtool with
six angles with a screwdriver to
3
open the side panel.
Wipe it with a cloth.
Regular cleaning drainage routes,
can effectively inhibit bacterias.
1
Full level
Remove the air filter
Pull out the handle of the air filter.

Cleaning the air filter

Beat it lightly by hand or
use a vacuum cleaner.
If it is very dirty, wash it off
with cold or warm water.
2
(Not for HEPA filter)
Re-attach to the unit.
Insert it all the way in, until it
stops.(If it is not in place, the
dirt or dust will enter the unit
and shorten its service life.)
WARNING
Before you clean the unit,
turn off the power switch.
Do not splatter water on
the unit
Caution
Wear gloves when cleaning.
The antibacterial coating is effective when
the bacteria exposed the coated surfaces
(See the shade areas on the figure)
The antibacterial coating becomes not
effective when the surfaces get very dirty.
Cleaning the air filter
Around once a week
Air filter