Connect Hose And Water Supply To Pump - Generac 1675-0 El Manual Del Propietario

WARNING!
Never fill fuel tank completely full.
Provide space for fuel expansion. Wipe away any fuel
spillage from engine and equipment before starting.
• Use fresh, clean unleaded automotive gasoline and store in
approved, clean, covered containers. Use clean fill
funnels. Never use "stale" gasoline left over from last
season or gasoline stored for long periods.
• Clean area around fuel fill cap, remove cap.
• Slowly add gasoline to fuel tank. Use a funnel to prevent
spillage. Fill tank to "Fuel Level Mark", as shown in
Figure 7.
Figure 7 — Add Gasoline to Fuel Tank
• Install fuel cap and wipe up any spilled gasoline.
Connect Hose and Water Supply to
Pump
IMPORTANT: You must assemble the nozzle extension
and attach all hoses before you start the engine. Starting
engine without all hoses connected and water supplied will
damage the pump.
NOTE: Your pressure washer comes with a quick connect
that you can use to attach the high pressure hose to either
the pump or spray gun.
• Uncoil the high pressure hose and attach the female quick
connect to one end of the hose. Attach the male quick
connect to the high pressure fitting on the pump (Figure 8).
Figure 8 — Attach Quick Connect
Generac 2,400 PSI Pressure Washer
• Attach the high pressure hose to the high pressure outlet
NOTE: The quick connect is shown connecting the high
pressure hose to the pump. If you choose to use the quick
connect for the gun to hose connection, follow the same
directions to attach quick connect from gun to hose.
• Attach the other end of the hose to the base of the
• Before you connect your garden hose to the water inlet,
• Run water through the garden hose for 30 seconds to
• Connect the garden hose to the water inlet. Tighten by
7
on the pump (Figure 9). Pull down on the collar of the
quick connect, slide fitting into the pump and let go of
collar. Pull on hose to be sure of a tight connection.
Figure 9 — Connect High Pressure Hose to Pump
spray gun (Figure 10). Tighten by hand.
Figure 10 — Connect High Pressure Hose to Spray Gun
inspect the inlet screen (Figure 11). Clean the screen if it
contains debris, replace it if it is damaged. DO NOT
RUN THE PRESSURE WASHER IF THE SCREEN IS
DAMAGED. NEVER SIPHON INLET WATER.
Figure 11 — Connect Garden Hose to Water Inlet
clean out any debris. Turn off water.
hand (Figure 11).
Connect high
pressure hose
here
Inspect inlet
screen, Do
Not use if
damaged, clean
if dirty.