Figure 15 — Throttle Lever Positions
Throttle Lever
• Grasp starter grip and pull slowly until you feel some
resistance. Then pull cord out with rapid full arm stroke.
Let rope return slowly. Do Not let rope "snap back"
against starter.
• If the engine fails to start repeat above steps or refer to
the engine owner's manual.
• If the choke was pulled to the CLOSED position to start
the engine, slowly push it to the OPEN position as the
engine runs smoother.
NOTE: If the recoil starter is hard to pull, it may be
necessary to squeeze the gun trigger to relieve internal
pump pressure.
How to Stop Pressure Washer
• Move Throttle Control lever to the 'Stop' position.
• Simply shutting off the engine will not release pressure in
the system. Squeeze trigger on the spray gun to
relieve pressure in the hose.
NOTE: A small amount of water will squirt out when you
squeeze the trigger.
Generac 2,400 PSI Pressure Washer
How to Use Accessory Tray
The unit is equipped with an accessory tray with places to
store your nozzle extension and quick connect nozzles, and
slots to hold the cleaning solution bottle and the detergent
siphoning filter. There are also two hooks at the ends of
On
the handle to hold your spray gun and high pressure hose.
NOTE: The extra holes in the tray are for storing a brush
and a turbo wand. The brush and turbo wand are NOT
included with your pressure washer. You can buy these
items as optional accessories.
Stop
• Place the nozzle extension through the hole on the
• Hang your chemical solution bottle on the "J" hook and
• Place the spray gun on the hook attached to the
• Hang the high pressure hose on the hook attached to
9
accessory tray, as shown in Figure 16.
Figure 16 — Accessory Tray
place the detergent siphoning filter in the last slot on the
left (Figure 16).
accessory tray on the right side of the unit (Figure 16).
the accessory tray on the left side of the unit as shown
on page 4.