Environmental Protection - Casals LM1000EA Instrucciones Originales

When the motor labours the revolutions of the mo-
tor will drop and you will hear a change in the mo-
tor sound. When this occurs stop mowing, release
the switch lever and raise the height of cut. Failure
to do so could damage the machine.
NOTE: The motor is protected by a safety cut–out
switch which is activated when the blade becomes
jammed or if the motor is overloaded. When cut-
out occurs, stop mowing and disconnect the lawn
mower from the power supply. Clear any obstruc-
tion and wait for a few minutes for the safety cut
out switch to reset before continuing to use the
mower. If the mower cuts out again increase the
height of cut to reduce the load on the motor.
NOTE: The temperature of the motor will rise
quickly, if the lawn mower frequently jams. If the
motor overheats, the safety cut out switch will
operate and will cut off the power. If this occurs,
you will need to disconnect the lawn mower from
the power supply and wait for it to cool down
completely. You will need to wait for approxi-
mately 1 hour before you can start using the
mower again.
Blade Removal (Fig.7)
• Switch off the lawnmower and disconnect from
the mains supply.
• Before removing the blade it is advisable to thor-
oughly clean the underside of the machine.
• Always wear work gloves when working on blade.
Note which way the blade is fitted. Hold the blade
firmly with one hand and using the spanner to
remove the blade securing bolt anticlockwise.
Remove the blade and thoroughly clean the area
around the shaft.
Blade Re-fitting
Align the blade onto the drive shaft ensuring that
the mark on the blade is on the outside and the
two studs on the back of the fan are located into
the corresponding two holes in the blade. Tighten
blade securing bolt clockwise, do not over tighten.
Check to ensure the blade is located correctly
before using the lawnmower.
Grass box: (Fig.8)
• The lawnmower is fitted with a grass box. To
attach the grass box, raise the flap on the mower
body, align the mounting holes on the grass box
with the bulges on the mower body.
To remove the grass box, raise the flap on top of
the grass box, lift the grass box upwards to detach
grass box from mower body.
• Warning: Keep the grass box securely attached
to the lawnmower while mowing.
Eliminating Faults
The machine fails to operate
• Check the power, and turn the power on
• Check the plug, replace the blown fuse.
• If the overheat protection has activated, allow the
machine to cool down and increase the height of
cut before carrying on
The machine leaves ragged finish or motor
• The height of cut is low, increase the height of
cut.
• Cutting blade blunt, replace new blade.
Excessive vibration/noise
• The blade bolt is loose, tighten blade bolt.
• Cutting blade damaged, replace new blade.
Technical Data.
Model Number:
Voltage
Power Input:
Speed:
Cutting Width:
Cutting height:
LpA: (Sound Pressure
Level)
LwA: (Sound Power
Level)
Grass box Capacity:

Environmental protection

Do not dispose of the machine,
accessories and packaging simply
in the rubbish, but rather take them
to an environmentally friendly
recycling station. This small effort
is good for our environment.
LM1000EA
230-240V~ 50Hz
1000W
3200/min
300mm
25/40/55mm
74.5dB K=1.2dB
96dB
5L