Rollei Lion Rock 30 Mark II Guia Del Usuario página 3

Lion Rock 30 Mark II instructions
Many thanks for choosing a Rollei product. This tripod out of the series Lion Rock Mark II is highly professional and offers huge stability as well as an extremely
high loading capacity. This tripod is the ideal option for travel and nature photographers. Please find all further functions described within the next paragraphs.
Please read this manual carefully before using this product.
1. Parts of the Tripod
Base plate
Platform locking knob
Leg angle adjustment lock
Leg locking system
Rubber feet
3.1
3. Tripod Legs
3.1 The angle of the tripod legs can be adjusted in three different positions. Therefore please pull out the
leg angle adjustment lock. Then you are able to move the leg up and down.
High angle Middle angle
3.2 The tripod leg consists of 4 segments and three of them can be extended smoothly. Therefore open
the leg lock system by turning it counter clockwise with a 1/4 rotation. Then you can extend or re-
tract the legs. If the desired length of each segment is achieved lock the mechanism again by turning
it clockwise until it is not able to turn around any further.
3.3 Underneath the rubber feet you will find the integrated spikes. These spikes can be used in areas
with soil, mud and so on where you need a better grip for the tripod. To use the spikes just pull off
the rubber feet. In the unlikely event that you lose the rubber feet you will find 3 extra rubber feet
inside the packaging. In the unlikely event that the spikes get loose please use the wrench to tighten
them again.
Model
Leg Sections Min. High
Lion Rock 30 Mark II 4 14.5 cm
ENGLISH
3.3
Low angle
Max. High Folded Size Max. Ø
148.5 cm 57.5 cm 36 mm 2.344 kg
Tripod shoulder
Security lock button
Tripod leg
3.2
Weight Load
30 kg
2. The Base Plate
1. The base plate is equipped with a 3/8 inch
screw. With this screw you can attach a tripod
head* onto the tripod.
2. We recommend that you also lock the tripod
head* onto the base plate. Therefore screw
the anti-rotating screw from below the base
plate in the direction of the head. Then the
tripod head* is firmly attached to the plate
and cannot accidentally be screwed off.
3. Loosen or tighten the mounting plate by
moving the tensioning screw upwards or
downwards. If necessary pull the screw
outside, then move it up or down and release
it again. Repeat this so often until the plate is
loosened or secured. To remove the base plate
completely push the security lock button and
take the plate out.
*Tripod head not included into the packaging.
4. Maintenance
• If necessary, please use the soft towel with
moderate detergent to clean the locking
system and the gliding parts.
• If necessary, please use regular lubricants or
wax oil.
Subject to technical changes.
3