Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Configuration
(Standalone)
Sound Mixed
Effect Sound-
Active Mode
Auto Mixed
Effect Automatic
Mode
Show Settings
Master/Slave
Mode
Page 20 of 96
Set the product in one of the Standalone modes to control without a DMX controller.
Connect the product to a suitable power outlet.
Never connect a product that is operating in any Standalone mode (Automatic or Sound-
Active) to a DMX string connected to a DMX controller. Products in Standalone mode may
transmit DMX signals that could interfere with the DMX signals from the controller.
To enable the sound mixed effect (Sound-Active All) mode, do the following:
1.
Press <MENU> repeatedly until SM** blinks on the display.
2.
Press <ENTER>.
3.
Use <UP> or <DOWN> to select the desired Sound-Active mode (SM01 or SM02).
4.
Press <ENTER> to put the fixture into the selected Sound-Active mode.
Turn the music on and adjust the sound sensitivity knob until the product starts responding to
the beat of the music.
· The product will only respond to low frequencies of music (bass and drums).
· The laser will blackout when in Sound-Active mode after 3 seconds of silence or noise
below the sensitivity setting.
To enable the auto mixed effect (Automatic All) mode, follow the instructions below:
1.
Press <MENU> repeatedly until AM** blinks on the display.
2.
Press <ENTER>.
3.
Use <UP> or <DOWN> to select the desired Automatic mode (AM01 or AM02).
4.
Press <ENTER>.
5.
Use <UP> or <DOWN> to adjust the mode speed, F 01 (fast) to F 99 (slow).
6.
Press <ENTER>.
To choose mixed style effect shows or Par-only effects, follow the instructions below and refer to
the
Menu Map
for programming steps:
1. Press <MENU> repeatedly until SHOW blinks on the display.
2. Press <ENTER> to next programming level.
3. Use <UP> or <DOWN> to scroll through the different individual Auto or Sound show options.
4. Press <ENTER> to put the fixture into the selected mode.
5. Use <UP> or <DOWN> to adjust the mode speed, F 01 (fast) to F 99 (slow).
6. Press <ENTER>.
The Master/Slave mode allows a single GigBAR™ IRC product (the master) to control the
actions of one or more GigBAR™ IRC products (the slaves) without the need for a DMX
controller. The master will be set to operate in either Automatic or Sound-Active mode, while the
slaves will be set to operate in Slave mode. Once set and connected, the slave units will operate
in unison with the master.
Configure the products as indicated below.
For every slave:
1.
Press <MENU> repeatedly until Slav blinks on the display.
2.
Press <ENTER> to put the fixture in Slave mode. The display will continue to blink.
3.
Repeat steps 1 and 2 for every slave.
4.
Connect the DMX output of the first slave unit to the DMX input of the next slave unit.
5.
Connect the DMX input of each subsequent slave unit to the DMX output of the previous
slave unit.
· Configure all the slave units before connecting the master to the DMX daisy chain.
· The display on the slaves will continue to blink until the slaves are receiving a DMX
signal from the master.
GigBAR™ IRC User Manual Rev. 2
Publicidad
Tabla de contenido
