Harness Adjustment - Cosatto MOOVA Guía De Instrucciones

Ensure the lap belt fits in the belt guide (b) and the diagonal belt fits in belt guides (c) and (d).
Attach the seat belt to the correct seat belt anchorage point (e).
Pull the diagonal section of the seat belt tight at point (f)
Fit the red clip close to the anchorage point to lock the belt (g).
IMPORTANT: The position of the seat belt/lap strap buckle can affect the stability of the child
car seat. In an accident this could stop the child car seat from protecting your child as well as it
should. If, when the seat belt/lap strap belt is properly tightened, the buckle lies in the position
marked then try fitting the child car seat in another seating position in your vehicle.

5 - harness adjustment

The shoulder straps must be threaded through the slots in the top cushion, front cover and seat
nearest the top of the child shoulders. If in any doubt always use the slot above the shoulder
rather than below it. However, once you reach the top slots your child may continue to use the
child car seat until their eye line is above the top of the seat shell or their weight exceeds 18Kg.
To move the shoulder strap from one slot to another loosen the harness by pushing the adjuster
button (a) in as you pull the shoulder straps forward as much as possible (b).
At the back of the child car seat, unclip the shoulder straps from the connector (c).
Feed the strap ends through the child car seat until they are clear of the cover (d).
Re-thread the shoulder strap back through your chosen shoulder slot (e). Make sure it is not twisted.
Repeat on the other shoulder strap.
Hook the shoulder straps back onto the connector (f).
Pull the adjustment strap forward to remove any slack (g).
6 - seating your child into the child car seat harness
Loosen the harness by pushing the adjuster button (a) in as you pull the shoulder straps (b)
forward as much as possible.
Unfasten the harness buckle by pressing the red button (c) and releasing the shoulder straps (d).
Place your child in the child car seat.
Fit the harness around your child and fasten the harness buckle by joining the shoulder straps (e)
and pushing them both into the buckle (f).
Check that the harness is not twisted and pull the harness up (g) to tighten the lap sections which
is designed to fit low down on your child's body.
Pull the adjuster strap forward (h) making sure the harness is a comfortable but FIRM fit around
your child.
Finally, pull both chest pads down (i) from your child's shoulders onto their chest.
Note: The chest pads are an important safety feature. Never use the car seat without
them.
7 - removing the covers
Loosen the harness by pushing the adjuster button (a) in as you pull the shoulder straps (b)
forward as much as possible.
Pull the connector out from behind the seat-belt guard. Unhook the shoulder straps from
the connector (c). Pull the shoulder straps through to the holes in the seat. Remove the crotch and
lap straps by pulling on the buckle with one hand and with the other hand under the seat, twist the
end brackets, sideways and then push it up through the slot. Remove the harness and cushions from
the child car seat (d). Remove the crotch pad, lower cushion and chest pads from the straps.
Gently pull the cover off from the top of the child car seat.
To refit the cover simply reverse the above instructions.
Make sure the shoulder straps are threaded through the chest pads and that there are no twists in
the harness.
IMPORTANT - The cover is a safety feature. NEVER use the child car seat without it.