Making The Electrical Connections - ETI Solid State Lighting VT-4-70-840-MV-D Guía De Uso Y Cuidado

installation (continued)
2
Installing the cord grip
□ Remove the nut from the end of the cord grip (EE)
and insert the threaded end into the knock out
hole on the end of the fixture body (B).
B
4
Making the electrical
connections
□ Connect the hot and neutral (black and
white) wires from the electrical source
to the same color wires from the LED
driver box.
□ Connect the green ground wire from
the electrical source to the green/
yellow ground wire from the fixture
body (B).
□ If a 0-10V dimming circuit is available,
connect the purple and gray wires
from the electrical source to the same
color wires from the LED driver box.
□ If 0-10V dimming is not desired, wrap
the ends of the purple and gray wires
with electrical tape to cover the wires.
□ Cover each wire connection with a
wire connector (FF) and electrical tape
(not included).
3
Feeding the wires
□ Feed the wires from the electrical source through the cord
grip (EE) and into the fixture body (B).
□ Tighten the nut onto the cord grip (EE) to secure the wires.
EE
B
A
LED Driver Box
FF B
5
EE
Please contact 1-855-384-7754 for further assistance.
FF
www.ETiSSL.com