ETI Solid State Lighting 56567241 Manual De Uso Y Cuidado

NOTE: Keep your receipt and these
instructions for proof of purchase.
WARNING: Shut off the power at the
circuit breaker or fuse panel before
removing the old fixture, ballast, or
fluorescent tubes.
If you are unfamiliar with electrical
installations, we recommend you contact a
qualified electrician to do the installation.
INSTALLATION
NOTE: Installing contractor is responsible
for selecting a suitable location that can
support the weight of the fixture and
determining the method for mounting the
fixture before installing, based on the type
of ceiling.
Shut off power at the electrical panel
1
before beginning the installation.
Remove fixture and set aside to recycle
2
in accordance with local requirements.
Safety Rope
End Cap
Lens
A
Remove end trim from fixture by sliding it up.
3
Unlock lens at both ends of the fixture.
Lens swings open.
SURFACE MOUNTING
Keyhole
Knock out hole
Lens
Hold the fixture to the desired ceiling location and
5a
mark the two keyholes (47in. apart). Punch out
the desired knock out hole that will be used for
wiring.
If mounting to drywall: Drill two 3/4in. holes in
6a
the ceiling. Fasten the toggle bolt into the butterfly
nut (not included) before inserting the flaps of the
toggle bolt into the ceiling, but do not fully tighten.
NOTE: Toggle bolts are only to be used for
mounting the fixture to plaster or drywall surfaces.
The installing contractor is responsible for
selecting the appropriate mounting hardware.
USE AND CARE GUIDE
DIRECT/INDIRECT WRAP LIGHT
PACKAGE CONTENTS
Part Description
A Fixture
B Continuous Mounting Bracket
C Toggle Bolt
D Thumb Screws
E Ring
F C
G
H Jumper Wire
Hardware not shown to actual size.
ACCESSORIES AVAILABLE FOR PURCHASE:
MODEL # 95656724101
8" PENDANT/STEM MOUNT ACCESSORY KIT
Part Description
I
Screws
J
Plastic Drywall Anchor
K
Stem Mounting Kit Screws
L
Stem Mounting Kit Nut
M
Stem Mounting Kit Bracket
N
Ceiling Plate
O
Stem
Squeeze the tabs at both ends of the wire cover and
4
remove the wire cover.
Unplug the terminal ground wire from the fixture and the
wire cover.
A
Wire Connector
Lens
Insert the ring into the knock out hole and feed the
7a
wires from the fixture through the ring.
Make the electrical connections by inserting the wire
8a
into the respective wire connector:
Black wire to black wire.
White wire to white wire.
Green wire to ground wire.
If a 0-10v dimming circuit is available, connect
purple wire to purple wire and gray wire to gray
wire.
Tuck wires inside the electrical box.
Quantity
1
1
2
B
2
1
2
2
5
Quantity
2
2
I
2
2
2
M
2
2
Lens
A
Terminal
Ground Wire
Wire Cover
A
E
9a
Part # WR-4FT-6700LM-8-40K-MV-LVD
Certification # 56567241
C D
F G
H
J K L
N O
C
A
Place the keyholes in the fixture around the toggle
bolts in the ceiling and tighten the toggle bolts. Make
sure the fixture is secure.
Model # 56567241
A
E
C