Linking Feature - ETI Solid State Lighting ST-2-9-840-SV-N Guía De Uso Y Cuidado

Linking Feature

WarninG: RISK OF ELECTRIC SHOCK. Disconnect power to the strip light before linking additional strip lights.
□ Multiple light fixtures can be connected, up to a maximum of 30 Strip Lights or 300 total watts. Only the first light fixture needs to be
plugged into an electrical outlet or direct wired to an electrical box.
WarninG: Provide power to the fixtures only after all linking connections have been made.
□ Connect each additional fixture using either the linking cable (EE) or end-to-end connector (DD). Remove the end cover (CC) and firmly
and fully insert either the end-to-end connector (DD) or linking cable (EE) into the receptacle in the end of each fixture body (B).
nOTiCe: When using the linking cable (EE), the maximum distance between two light fixtures is 12 in. using the linking cable (EE) provided, or 5 ft.
using the 5-ft. linking cable (II) available as a separate accessory.
WarninG: RISK OF ELECTRIC SHOCK. If the receptacle on the end of the strip light is not used to link to another fixture, the receptacle needs
to be closed by the end cover (CC). Do not touch live parts inside the receptacle.
□ Connect up to a maximum of 30 strip lights. Do not exceed 300 total watts for interconnected lights. The table shows the maximum
quantity of linkable strip lights that can be connected, based on wattage.
Model
54263143
54261143
CaUTiOn: If using linking cable to connect strip lights, affix the linking cable to the ceiling using cord clips or cable raceway (not included).
CaUTiOn: For safety, linked strip lights can either be installed as plug-in or direct wire, but never a combination of both.
CC
DD
Length Wattage
2 ft. 10W
4 ft. 20W
B
EE
Maximum # of Connected Strip Lights
11
Please contact 1-855-384-7754 for further assistance.
B
B
30
15
www.ETiSSL.com