Suspension Mounting - ETI Solid State Lighting ST-2-9-840-SV-N Guía De Uso Y Cuidado

suspension Mounting

nOTe: Separate mounting hardware (not included) not shown to actual size.
nOTe: When determining the desired location for suspension mounting the light fixture using the plug-in installation method, make sure the
light fixture is located directly below the electrical outlet and that the distance between the electrical outlet and the end of the light fixture is
less than 5 ft.
nOTe: Eye hooks can be used as an alternate method of attaching the fixture to the ceiling.
nOTe: Toggle bolts
1
Mounting to ceiling
□ Drill two 1/16 in. diameter holes in the ceiling to accommodate hook
screws (not included). Make sure to fasten the combo wood-machine
end into the metal hook.
□ Tighten the hook screws (not included) into the studs.
nOTe: If using eye hooks in the ceiling instead, attach the chain with S hooks.
2
Attaching the light to the chain
□ Attach the S hook at the bottom of the mounting
chain (not included) to the fixture body (B). Repeat
this step on the other side of the fixture.
nOTe: Product should be suspended using metal chain or
cable and hooks with weight bearing capacity exceeding 11 lbs
(5 KG). S hooks must be ≤ 0.1 in. (2.5 mm) to fit the holes in the
fixture body (B).
(not included)
can be used as an alternate method of attaching the fixture to the ceiling.
B
3
Attaching the chain to the ceiling
□ Hang the fixture body (B) by placing one chain over each
hook (not included) that has been installed on the ceiling.
□ Adjust chains to level light.
nOTe: If using eye hooks in the ceiling instead, attach the top
of the chain with S hooks.
9
Please contact 1-855-384-7754 for further assistance.
www.ETiSSL.com